Difficulty
Moderate
Steps
10
Time Required
15 minutes
Sections
5
- Back Cover
- 2 steps
- Battery
- 2 steps
- Bezel
- 2 steps
- Rear Casing
- 2 steps
- Speaker
- 2 steps
Flags
0
BackKindle Touch
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Use the plastic opening tool to undo the ten plastic clips around the back panel of the Kindle.
Use the plastic opening tool to undo the ten plastic clips around the back panel of the Kindle.
1024
Step 2
- Gently lift the bottom and slide the panel off.
Gently lift the bottom and slide the panel off.
Step 3
Battery
- Use a Phillips #00 screwdriver to remove the five screws.
Use a Phillips #00 screwdriver to remove the five screws.
Step 4
- Using the flat end of your spudger, gently pry the battery up and remove it.
Using the flat end of your spudger, gently pry the battery up and remove it.
Step 5
Bezel
- Using a Phillips #00 screwdriver, remove the six 4 mm screws to access the front plate.
Using a Phillips #00 screwdriver, remove the six 4 mm screws to access the front plate.
Step 6
- Use the plastic opening tool to pry the bezel from the top and sides
- The bottom of the bezel will be glued, so be careful when sliding the clips out.
- The clips can be easily bent, so do not try to force them out. If you do bend some, they can be bent back.
Use the plastic opening tool to pry the bezel from the top and sides
The bottom of the bezel will be glued, so be careful when sliding the clips out.
The clips can be easily bent, so do not try to force them out. If you do bend some, they can be bent back.
Step 7
Rear Casing
- Use your Phillips #00 srewdriver to remove the indicated screws.
- There are three pairs of screws that are each different. The screws on the top corners are 4 mm #00 Phillips screws, the screws on the bottom corners are 2 mm #00 Phillips screws, and the black bottom center screws are 6 mm #00 Phillips screws.
Use your Phillips #00 srewdriver to remove the indicated screws.
There are three pairs of screws that are each different. The screws on the top corners are 4 mm #00 Phillips screws, the screws on the bottom corners are 2 mm #00 Phillips screws, and the black bottom center screws are 6 mm #00 Phillips screws.
Step 8
- With the screws removed, gently remove the case from the internals.
With the screws removed, gently remove the case from the internals.
Step 9
Speaker
- Use the pointy end of your Spudger to separate the Speaker’s connector from the motherboard on both sides.
Use the pointy end of your Spudger to separate the Speaker’s connector from the motherboard on both sides.
Step 10
- The speakers are held down solely with contact adhesive, so use your Spudger to pry them from the support board.
The speakers are held down solely with contact adhesive, so use your Spudger to pry them from the support board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Adam Yerly
Member since: 01/20/2015
1,885 Reputation
7 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 19-5, Blackwell Winter 2015
Member of USF Tampa, Team 19-5, Blackwell Winter 2015
USFT-BLACKWELL-W15S19G5
3 Members
8 Guides authored