Kindle Fire Hd 10 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          20 minutes            

Sections

1

• Battery
• 4 steps

Flags

0

• History
• Save to Favorites
• Download PDF
• Edit
• Translate
• Get Shareable Link
• Embed This Guide
• Notify Me of Changes
• Stop Notifications

Introduction

The batteries wear out over time due to repeated charging cycles. If you notice a decrease in performance from your battery, you may need to replace your battery. For further information look at this link below:

Warning: before you start working on replacing your battery, make sure your Kindle Fire HD 10 device is turned off and the charger is disconnected.

What you need

Step 1

              Battery               

• Pry open the case using the iFixit opening tool. Make sure to go around the whole case before removing the whole case.
• Some force is required to remove the back cover. In order to remove the casing successfully, keep the clips holding the cover from “popping” back in.

Pry open the case using the iFixit opening tool. Make sure to go around the whole case before removing the whole case.

Some force is required to remove the back cover. In order to remove the casing successfully, keep the clips holding the cover from “popping” back in.

1024

Step 2

• Remove the plastic yellow taping from the wire circuits using a pair of tweezers.

Remove the plastic yellow taping from the wire circuits using a pair of tweezers.

Step 3

• With slight force pry off the cable connecter using a spudger.

With slight force pry off the cable connecter using a spudger.

Step 4

• Remove the ten 4mm screws from the outsides of the battery with a Phillips #0 screwdriver.
• Lift out the battery from its resting position using your fingers.

Remove the ten 4mm screws from the outsides of the battery with a Phillips #0 screwdriver.

Lift out the battery from its resting position using your fingers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.                                             

Author

                                      with 6 other contributors 

                    Jonathan Stewart                     

Member since: 09/19/2019

294 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S1-G5, Watkins Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S1-G5, Watkins Fall 2019 



                    ERAU-WATKINS-F19S1G5                     


                                            4 Members                     


                                            10 Guides authored                     

JoeBlog - Jul 15, 2021

Reply

I cannot open a SL056ZE.

I mean I opened it up to all around it, it lifts but there seems to be part of ‘blue’ plastic cover - internally - that is kind of locked into right side of PCB [looking at it with battery below !

Any ideas?