Difficulty

Easy

Steps

6

Time Required

                          10 minutes

Sections

2

  • Secondary Water Pump
  • 4 steps
  • Lid Spring
  • 2 steps

Flags

0

  • BackKeurig K55

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Secondary Water Pump
  • Lift the silver handle up.
  • Locate the screw and washer holding the handle in place on each side.
  • Remove both 13mm screws and washers using a Phillips #0 screwdriver.

Lift the silver handle up.

Locate the screw and washer holding the handle in place on each side.

Remove both 13mm screws and washers using a Phillips #0 screwdriver.

1024

Step 2

  • Grab the handle and pull it upward and toward the rear of the device.
  • Lift the lid to the fully open position.
  • Remove the two 11mm Phillips screws located on the upper part of the device.
  • Be careful removing the screws; the needle here may be sharp.

Grab the handle and pull it upward and toward the rear of the device.

Lift the lid to the fully open position.

Remove the two 11mm Phillips screws located on the upper part of the device.

Be careful removing the screws; the needle here may be sharp.

Step 3

  • Lower the lid to just before its closing position.
  • Grab the black top cover with the Keurig logo and gently push back toward the rear of the device to release it.
  • Gently pull the top cover upward and toward the front of the device to remove it.

Lower the lid to just before its closing position.

Grab the black top cover with the Keurig logo and gently push back toward the rear of the device to release it.

Gently pull the top cover upward and toward the front of the device to remove it.

Step 4

  • Remove the two 11mm Phillips head screws securing the water pump.
  • Grab the secondary water pump firmly and pull one of the plastic water lines off of the pump.
  • Pull the other line from the water pump.

Remove the two 11mm Phillips head screws securing the water pump.

Grab the secondary water pump firmly and pull one of the plastic water lines off of the pump.

Pull the other line from the water pump.

Step 5

              Lid Spring
  • Pull the spring off the front hook using two fingers.
  • The spring has a lot of tension, so grip the spring end tightly.

Pull the spring off the front hook using two fingers.

The spring has a lot of tension, so grip the spring end tightly.

Step 6

  • Pull the spring off the other hook.

Pull the spring off the other hook.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    William O'Brien

Member since: 01/23/2018

500 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S1-G3, Livingston Winter 2018                        

                                                  Member of Cal Poly, Team S1-G3, Livingston Winter 2018 



                    CPSU-LIVINGSTON-W18S1G3                     


                                            4 Members                     


                                            5 Guides authored