Keurig B70 Platinum K Cup Portion Pack Holder Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          7 - 10 minutes            

Sections

1

• K-Cup Portion Pack Holder
• 4 steps

Flags

0

• BackKeurig B70 Platinum

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

This guide will show you how to remove and replace the K-Cup Portion Pack Holder for the Keurig B70 Platinum if you’re experiencing any problems with the pack holder. Before continuing with the guide, you’re going to need a Phillips #2 screwdriver.

What you need

Step 1

              K-Cup Portion Pack Holder               

• Turn off and unplug the Keurig before starting.
• Open the lid and remove the two 11.0 mm screws located below the K-Cup holder.

Turn off and unplug the Keurig before starting.

Open the lid and remove the two 11.0 mm screws located below the K-Cup holder.

1024

Step 2

• Pull the black plastic guard of the K-Cup housing away from the Keurig.
• Depending on the angle, the guard can actually fall out instead. Be ready to catch it!

Pull the black plastic guard of the K-Cup housing away from the Keurig.

Depending on the angle, the guard can actually fall out instead. Be ready to catch it!

Step 3

• Push the black button at the bottom of the lid to remove the K-cup holder assembly.
• From the top, lift the assembly out of the Keurig.

Push the black button at the bottom of the lid to remove the K-cup holder assembly.

From the top, lift the assembly out of the Keurig.

Step 4

• Grab the top and the bottom of the holder assembly and pull it apart.
• Be careful when pulling the assembly. There is a sharp needle!
• This step requires a little force.

Grab the top and the bottom of the holder assembly and pull it apart.

Be careful when pulling the assembly. There is a sharp needle!

This step requires a little force.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Thu Hoang                     

Member since: 10/17/2018

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       UW Tacoma, Team S1-G6, Rose Fall 2018                        

                                                  Member of UW Tacoma, Team S1-G6, Rose Fall 2018 



                    UWT-ROSE-F18S1G6                     


                                            4 Members                     


                                            5 Guides authored                     

slz2002 - Dec 26, 2019

Reply

Spring flew out as I was removing cup holder. Where does it go. How do I reinsert it?