Difficulty

Moderate

Steps

7

Time Required

                          10 - 25 minutes

Sections

2

  • Face Plate
  • 2 steps
  • LCD Screen
  • 5 steps

Flags

0

  • BackKenwood KDC-BT565U

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Face Plate
  • Press the eject button on the bottom left corner of the face plate.

Press the eject button on the bottom left corner of the face plate.

1024

Step 2

  • Begin by slightly lifting the face plate out from the side located by the release button.
  • Slide towards the side of the eject button, then completely lift out.

Begin by slightly lifting the face plate out from the side located by the release button.

Slide towards the side of the eject button, then completely lift out.

Step 3

              LCD Screen
  • Remove the four 7.5mm Phillips #0 screws on the back of the face-plate.

Remove the four 7.5mm Phillips #0 screws on the back of the face-plate.

Step 4

  • Use a spudger or prying tool to open the back of the face plate. Pry the back at multiple points around the edge of the face plate. This will take some patience. Applying too much force risks breaking the plastic.

Use a spudger or prying tool to open the back of the face plate. Pry the back at multiple points around the edge of the face plate. This will take some patience. Applying too much force risks breaking the plastic.

Step 5

  • Lift and remove the motherboard to reveal the inside of the front panel.
  • You might need to pry the right side up with the spudger.

Lift and remove the motherboard to reveal the inside of the front panel.

You might need to pry the right side up with the spudger.

Step 6

  • Use the plastic spudger to straighten out the six pegs to allow the removal of the LCD screen.
  • Make sure to use an ESD-safe prying tool when working on electrical boards. Here, we are using a plastic tool, not a metal one.

Use the plastic spudger to straighten out the six pegs to allow the removal of the LCD screen.

Make sure to use an ESD-safe prying tool when working on electrical boards. Here, we are using a plastic tool, not a metal one.

Step 7

  • Lift the LCD screen to remove and replace it.

Lift the LCD screen to remove and replace it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors 


                    Yusef Flowers

Member since: 02/15/2017

137 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team S2-G5, Lacy Spring 2017                        

                                                  Member of USF Tampa, Team S2-G5, Lacy Spring 2017 



                    USFT-LACY-S17S2G5                     


                                            4 Members                     


                                            11 Guides authored