Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Seat
- 4 steps
Flags
0
BackKawasaki Ninja 300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Seat
- Locate the bolt holding the side seat cover in place and remove it using a 4mm hex key.
- Make sure to also remove the bolt’s washer.
Locate the bolt holding the side seat cover in place and remove it using a 4mm hex key.
Make sure to also remove the bolt’s washer.
1024
Step 2
- Reach under the side seat cover and firmly pull it out to unseat it from its rubber clips. There is one at the rear of the cover and two at the front.
Reach under the side seat cover and firmly pull it out to unseat it from its rubber clips. There is one at the rear of the cover and two at the front.
Step 3
- Locate the seat bolt and remove it using a 5mm hex key.
- It’s best to use the longer end of the hex key, as the shorter end won’t quite fit.
- Make sure to also remove the bolt’s washer.
- Repeat these steps on the other side of the motorcycle before continuing on to the next step.
Locate the seat bolt and remove it using a 5mm hex key.
It’s best to use the longer end of the hex key, as the shorter end won’t quite fit.
Repeat these steps on the other side of the motorcycle before continuing on to the next step.
Step 4
- Grab the front section of the seat and slightly lift it up and back to remove it.
Grab the front section of the seat and slightly lift it up and back to remove it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
Craig Lloyd
Member since: 02/10/2016
28,344 Reputation
82 Guides authored
Badges:
41
+38 more badges
