Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Front Panel
  • 2 steps
  • Switch
  • 4 steps

Flags

0

  • BackKarcher Carpet Cleaner 1.006-673.0 (2014)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Follow this same procedure to remove the three other front panel switches. Note that the heater switch has an included light, so be sure to remove its accompanying power and ground wires if replacing.

The water switch and both pressure switches are part number 8.600-714.0, which the heater switch is part number 8.631-785.0.

Note: Before beginning repairs, disconnect the device from power, disconnect all hoses, drain and depressurize the system, and let the device cool if the heater was recently used.

What you need

Step 1

              Remove the screws securing the front panel
  • Before beginning repairs, disconnect the device from power, disconnect all hoses, drain and depressurize the system, and let the device cool if the heater was recently used.
  • Use a Phillips screwdriver to remove the six screws securing the front panel.

Before beginning repairs, disconnect the device from power, disconnect all hoses, drain and depressurize the system, and let the device cool if the heater was recently used.

Use a Phillips screwdriver to remove the six screws securing the front panel.

1024

Step 2

              Tilt the front panel down
  • Grip the front panel at the top and tilt down to reveal the switch electronics.
  • The front panel will stay attached to the device with the flexible tubing.

Grip the front panel at the top and tilt down to reveal the switch electronics.

The front panel will stay attached to the device with the flexible tubing.

Step 3

              Remove the wires from the switch
  • Grip the black ground wire by its blue connector and pull directly away from the switch to remove it.

Grip the black ground wire by its blue connector and pull directly away from the switch to remove it.

Step 4

  • Remove the grey wire from the switch.

Remove the grey wire from the switch.

Step 5

              Depress the retaining clips
  • Pinch the retaining clips on the back of the switch housing.
  • There are four retaining clips, two on the top and two on the bottom. All four will need to be depressed so the switch can slide out of the front panel.

Pinch the retaining clips on the back of the switch housing.

There are four retaining clips, two on the top and two on the bottom. All four will need to be depressed so the switch can slide out of the front panel.

Step 6

              Remove the switch
  • With all four retaining clips depressed, push the switch through and off of the front panel.
  • The switch will slide out of the front panel without much force.
  • Remove the switch.

With all four retaining clips depressed, push the switch through and off of the front panel.

The switch will slide out of the front panel without much force.

Remove the switch.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                    Carsten Frauenheim

Member since: 03/10/2020

81,713 Reputation

                                      330 Guides authored                  



                       Badges:
                       38







                                                        +35 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored