Difficulty

Moderate

Steps

6

Time Required

                          45 minutes

Sections

1

  • Eye Piece
  • 6 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackJVC GR-D93U

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Eye Piece
  • Unscrew two 3mm Phillips #0 screw from the bottom of the camera to remove blue plastic casing.

Unscrew two 3mm Phillips #0 screw from the bottom of the camera to remove blue plastic casing.

1024

Step 2

  • Unscrew two 3mm Phillips #0 screws. Then remove 6 3mm Philips #0 screws from the bottom of the camera.

Unscrew two 3mm Phillips #0 screws. Then remove 6 3mm Philips #0 screws from the bottom of the camera.

Step 3

  • Unscrew 3mm Phillips #0 screws from the batter port under the eye piece.

Unscrew 3mm Phillips #0 screws from the batter port under the eye piece.

Step 4

  • Now the camera can be split into two pieces. Be careful when removing the two sides and remove the cables connecting the two halves. There are also cables that need to be disconnected from the battery pack section.

Now the camera can be split into two pieces. Be careful when removing the two sides and remove the cables connecting the two halves. There are also cables that need to be disconnected from the battery pack section.

Step 5

  • Unscrew two 3mm Phillips #0 screws from around the eye piece. Then flip the camera over and unscrew 3mm Phillips #0 screw. Then unscrew 3mm Phillips #0 screw from under the eye piece.

Unscrew two 3mm Phillips #0 screws from around the eye piece. Then flip the camera over and unscrew 3mm Phillips #0 screw. Then unscrew 3mm Phillips #0 screw from under the eye piece.

Step 6

  • Unscrew 3mm Phillips #0 screw and disconnect cable. This will disconnect the eye piece from the camera.

Unscrew 3mm Phillips #0 screw and disconnect cable. This will disconnect the eye piece from the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Lindsay

Member since: 03/16/2015

267 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Colorado Springs, Team 1-5, May Spring 2015                        

                                                  Member of Colorado Springs, Team 1-5, May Spring 2015 



                    UCCS-MAY-S15S1G5                     


                                            4 Members                     


                                            3 Guides authored