Justin Bieber Concert Microphone Printed Circuit Board Pcb Replacement Repair Guide

Difficulty

Difficult

Steps

7

Time Required

                          10 minutes            

Sections

1

• Printed Circuit Board (PCB)
• 7 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

• BackJustin Bieber Concert Microphone

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Removing back panel               

• Remove the back panel of the device by unscrewing the single #8 11.6 mm Flathead screw on the back of the device.

Remove the back panel of the device by unscrewing the single #8 11.6 mm Flathead screw on the back of the device.

1024

Step 2

              Removing batteries               

• Remove the 3 AAA batteries from the device.

Remove the 3 AAA batteries from the device.

Step 3

              Removing back half of device               

• Unscrew the other 4, #8 11.6 mm Phillips Head screws to remove the entire back half of the device.
• Pull apart the device once screws are loose, splitting the device in half.

Unscrew the other 4, #8 11.6 mm Phillips Head screws to remove the entire back half of the device.

Pull apart the device once screws are loose, splitting the device in half.

Step 4

              Positioning device               

• Keeping all wires connected to their attachments, place the front half of the device face down.

Keeping all wires connected to their attachments, place the front half of the device face down.

Step 5

              Inspecting PCB               

• Inspect the printed circuit board for any breaks or cracks.

Inspect the printed circuit board for any breaks or cracks.

Step 6

              Removing PCB               

• Remove the 2, #8 11.7 mm Phillips Head screws as well as the 2, #8 7.5 mm screws on the printed circuit board.

Remove the 2, #8 11.7 mm Phillips Head screws as well as the 2, #8 7.5 mm screws on the printed circuit board.

Step 7

              Replacing PCB               

• Disconnect all wires from the PCB
• Remove the damaged PCB from the microphone
• Place new PCB in the Justin Bieber Concert Microphone.
• Connect all the wires to the new PCB using this soldering guide.

Disconnect all wires from the PCB

Remove the damaged PCB from the microphone

Place new PCB in the Justin Bieber Concert Microphone.

Connect all the wires to the new PCB using this soldering guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Mike Seyman                     

Member since: 10/19/2014

437 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Baylor, Team 4-1, Williams Fall 2014                        

                                                  Member of Baylor, Team 4-1, Williams Fall 2014 



                    BU-WILLIAMS-F14S4G1                     


                                            3 Members                     


                                            4 Guides authored