Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

1

  • Jura Drainage valve (2)
  • 8 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackJura (Capresso) Impressa J

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Jura Drainage valve (2)
  • The brewing group has already been removed and disassembled. Now it’s time for the drainage valve.
  • There will be many pictures
  • All you need a small flathead screwdriver.

The brewing group has already been removed and disassembled. Now it’s time for the drainage valve.

There will be many pictures

All you need a small flathead screwdriver.

1024

Step 2

  • Images front and back

Images front and back

Step 3

  • Pull off the clamp and pull out the inlet hose. At the end there is a seal, it often gets stuck in the drainage valve. Swap them out when reassembling.

Pull off the clamp and pull out the inlet hose. At the end there is a seal, it often gets stuck in the drainage valve. Swap them out when reassembling.

Step 4

  • Pull out the clip on the docking tube
  • Pry out the valve body. Make sure the white cap slides out of its hole.
  • Detach the docking nozzle.

Pull out the clip on the docking tube

Pry out the valve body. Make sure the white cap slides out of its hole.

Detach the docking nozzle.

Step 5

  • Detailed photos.
  • The position of the sealing rings are marked green in picture 3.
  • The sealing ring on the docking socket is marked in red in picture 2. It is especially important. It’s a little thinner than the other two.
  • The brackets are marked in red.

Detailed photos.

The position of the sealing rings are marked green in picture 3.

The sealing ring on the docking socket is marked in red in picture 2. It is especially important. It’s a little thinner than the other two.

The brackets are marked in red.

Step 6

  • Here all the parts of the valve.

Here all the parts of the valve.

Step 7

  • Here is the entire valve in one picture

Here is the entire valve in one picture

Step 8

  • Reassembly
  • When assembling, make sure that the lips of the seals point to the pressure side, i.e. inward, and the flat side outward.
  • When installing, make sure that the pressure hose runs through the slot in the valve carrier.

Reassembly

When assembling, make sure that the lips of the seals point to the pressure side, i.e. inward, and the flat side outward.

When installing, make sure that the pressure hose runs through the slot in the valve carrier.

Follow the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             


        These translators are helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

Schwarzstein

Troy weglinski

Annika Faelker

VauWeh

and 1 other…

                 +1

Author

                                      with 2 other contributors 


                    Schwarzstein

Member since: 07/15/2013

2,741 Reputation

                                      13 Guides authored                  



                       Badges:
                       21







                                                        +18 more badges