Difficulty
Difficult
Steps
9
Time Required
10 minutes
Sections
2
- Motherboard
- 7 steps
- Indicator Light
- 2 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackJumper AngelSounds JPD-100S
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Access the battery compartment
- Remove the battery compartment lid and set it aside.
- Disconnect the battery and set it aside.
Access the battery compartment
Remove the battery compartment lid and set it aside.
Disconnect the battery and set it aside.
1024
Step 2
- Puncture the sticker in the battery compartment with a spudger to access the screw beneath it.
Puncture the sticker in the battery compartment with a spudger to access the screw beneath it.
Step 3
- Remove the 7mm Phillips #1 screw from the battery compartment.
- Place the screw in a secure place.
Remove the 7mm Phillips #1 screw from the battery compartment.
Place the screw in a secure place.
Step 4
- Begin prying open the device.
- Insert a plastic opening tool into the side groove about 2cm from the pink plastic component and pry open one side of the device.
- Once the side is separated, leave the opening tool inside to prevent the two sides from closing.
Begin prying open the device.
Insert a plastic opening tool into the side groove about 2cm from the pink plastic component and pry open one side of the device.
Once the side is separated, leave the opening tool inside to prevent the two sides from closing.
Step 5
- Insert another plastic opening tool into the groove opposite to the side of the tool already inserted.
- Create separation on that side until the white plastic component comes off entirely.
- Place the white plastic component in a secure place.
Insert another plastic opening tool into the groove opposite to the side of the tool already inserted.
Create separation on that side until the white plastic component comes off entirely.
Place the white plastic component in a secure place.
Step 6
- With your hand, remove the pink component.
With your hand, remove the pink component.
Step 7
- Remove the 7mm Phillips #1 screw in the middle of the motherboard.
Remove the 7mm Phillips #1 screw in the middle of the motherboard.
Step 8
Indicator Light
- Place the motherboard in a position that allows access it’s underside.
- Pre-heat the soldering iron.
Place the motherboard in a position that allows access it’s underside.
Pre-heat the soldering iron.
Step 9
- Desoldering
- If steam is created when the soldering iron is touched to a wet sponge then the soldering iron is hot enough.
- Use the soldering iron and soldering vacuum to unsolder the indicator light leads.
- Plastic spacer holding indicator light may burn.
Desoldering
If steam is created when the soldering iron is touched to a wet sponge then the soldering iron is hot enough.
Use the soldering iron and soldering vacuum to unsolder the indicator light leads.
Plastic spacer holding indicator light may burn.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Deron Rogers
Member since: 08/31/2015
271 Reputation
2 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 6-1, Remmell Fall 2015
Member of USF Tampa, Team 6-1, Remmell Fall 2015
USFT-REMMELL-F15S6G1
6 Members
6 Guides authored
