Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Jolla C or Intex Aqua Fish Teardown
  • 5 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackJolla

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Phone & Back Cover
  • Remove the back cover, starting at the bottom right corner with your nail or a prying tool

Remove the back cover, starting at the bottom right corner with your nail or a prying tool

1024

Step 2

              Battery, Sims & SD
  • Remove the battery
  • Remove all sim-cards
  • Remove the microSD-card

Remove the battery

Remove all sim-cards

Remove the microSD-card

Step 3

              Middle Cover
  • Remove all 14 cross-head screws
  • Use a prying tool to separate the middle cover from the phone, working from the bottom slowly up to the top
  • Watch out for the power and volume buttons, which probably fall out of the device.

Remove all 14 cross-head screws

Use a prying tool to separate the middle cover from the phone, working from the bottom slowly up to the top

Watch out for the power and volume buttons, which probably fall out of the device.

Step 4

              Top Circuit Board
  • Remove all cross-head screws
  • Remove the antenna wire from the circuit board
  • Pry loose the power & volume button part at the side (it is stuck to the phone with sticky tape) and pull it out
  • Pull out the connector for the bottom cuircuit board
  • Pull out the screen connector
  • Pry loose the connector for the proximity sensor etc
  • Now you can remove the top circuit board
  • Remove the main and front camera connectors

Remove all cross-head screws

Remove the antenna wire from the circuit board

Pry loose the power & volume button part at the side (it is stuck to the phone with sticky tape) and pull it out

Pull out the connector for the bottom cuircuit board

Pull out the screen connector

Pry loose the connector for the proximity sensor etc

Now you can remove the top circuit board

Remove the main and front camera connectors

Step 5

              Bottom Cuircuit Board
  • Remove the antenna cable
  • Remove the speaker and vibration motor from the phone
  • Both items are stuck to the phone and the cables are very fragile. I broke one of the connections when removing the speaker for a second time, as seen in the second picture. It is possible to solder it back on

Remove the antenna cable

Remove the speaker and vibration motor from the phone

Both items are stuck to the phone and the cables are very fragile. I broke one of the connections when removing the speaker for a second time, as seen in the second picture. It is possible to solder it back on

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Jos Wagenmakers

Member since: 03/20/2017

131 Reputation

                                      1 Guide authored                  



                       Badges:
                       3