Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
1
- Cartridge/Needle
- 4 steps
Flags
0
BackJensen JTA-230
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 1
Cartridge/Needle
- Open the dust cover
Open the dust cover
1024
Step 2
- Next, lift up the clip that holds the tone arm in place and lift the tone arm out.
Next, lift up the clip that holds the tone arm in place and lift the tone arm out.
Step 3
- The cartridge and needle is the red piece at the end of the tone arm. To remove it, simply grab the end on each side and pull back slowly. The piece should slide right off the tone arm
The cartridge and needle is the red piece at the end of the tone arm. To remove it, simply grab the end on each side and pull back slowly. The piece should slide right off the tone arm
Step 4
- Once you have the replacement piece it goes on slight different. Instead of it sliding back on, it clips back on. Once the new piece is secured back on it is good to go.
Once you have the replacement piece it goes on slight different. Instead of it sliding back on, it clips back on. Once the new piece is secured back on it is good to go.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Louis Varrichione
Member since: 03/11/2016
309 Reputation
2 Guides authored
Badges:
15
+12 more badges
Team
UMass Dartmouth, Team 8-8, Botvin Spring 2016
Member of UMass Dartmouth, Team 8-8, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G8
3 Members
5 Guides authored