Jd Razor 2000 Handle Bar Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          10 minutes            

Sections

1

• Handle Bar
• 3 steps

Flags

Featured Student Guide

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

• BackJD Razor 2000

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Pulling Out the String               

• Firmly hold the handle bar in place.
• Grab with one hand the black removable tip of the handle bar and pull it out.
• Pull out the end of the tied string through the removable tip.

Firmly hold the handle bar in place.

Grab with one hand the black removable tip of the handle bar and pull it out.

Pull out the end of the tied string through the removable tip.

1024

Step 2

              Untying the Knot               

• Untie the knot at the end of the string.
• If you let go of the string while its in tension, it may recoil far into the other side of the handle bars. To avoid this, bring the end of the string inward towards the hollow section of the handle bar and then carefully let it go.

Untie the knot at the end of the string.

If you let go of the string while its in tension, it may recoil far into the other side of the handle bars. To avoid this, bring the end of the string inward towards the hollow section of the handle bar and then carefully let it go.

Step 3

              Pulling Out the Handlebar               

• Press down firmly on the golden fastening button located on the handle bar being replaced.
• While still pressing down on the fastening button, slide the handle bar apart from the T Bar.
• When re-installing the handlebar (after completion of the guide), you may need a pair of needle-nosed pliers to thread the string back through the handlebar.

Press down firmly on the golden fastening button located on the handle bar being replaced.

While still pressing down on the fastening button, slide the handle bar apart from the T Bar.

When re-installing the handlebar (after completion of the guide), you may need a pair of needle-nosed pliers to thread the string back through the handlebar.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Kevin Church                     

Member since: 10/16/2014

297 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 4-46, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 4-46, Amido Fall 2014 



                    CPSU-AMIDO-F14S4G46                     


                                            4 Members                     


                                            8 Guides authored                     

dantotford - May 28, 2016

Reply

Why is the stretchable string for?