Difficulty
Easy
Steps
6
Time Required
15 minutes
Sections
2
- Handle Bar
- 3 steps
- Fastening Button on Handle Bar
- 3 steps
Flags
0
BackJD Razor 2000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Pulling Out the String
- Firmly hold the handle bar in place.
- Grab with one hand the black removable tip of the handle bar and pull it out.
- Pull out the end of the tied string through the removable tip.
Firmly hold the handle bar in place.
Grab with one hand the black removable tip of the handle bar and pull it out.
Pull out the end of the tied string through the removable tip.
1024
Step 2
Untying the Knot
- Untie the knot at the end of the string.
- If you let go of the string while its in tension, it may recoil far into the other side of the handle bars. To avoid this, bring the end of the string inward towards the hollow section of the handle bar and then carefully let it go.
Untie the knot at the end of the string.
If you let go of the string while its in tension, it may recoil far into the other side of the handle bars. To avoid this, bring the end of the string inward towards the hollow section of the handle bar and then carefully let it go.
Step 3
Pulling Out the Handlebar
- Press down firmly on the golden fastening button located on the handle bar being replaced.
- While still pressing down on the fastening button, slide the handle bar apart from the T Bar.
- When re-installing the handlebar (after completion of the guide), you may need a pair of needle-nosed pliers to thread the string back through the handlebar.
Press down firmly on the golden fastening button located on the handle bar being replaced.
While still pressing down on the fastening button, slide the handle bar apart from the T Bar.
When re-installing the handlebar (after completion of the guide), you may need a pair of needle-nosed pliers to thread the string back through the handlebar.
Step 4
Depressing the Button
- Press strongly down on the golden fastening button located on the loose handle bar.
Press strongly down on the golden fastening button located on the loose handle bar.
Step 5
Grasping the Button
- Tilt the opening of the handle towards you.
- Reach in carefully with the small needle-nose pliers and firmly grab the golden fastening button.
Tilt the opening of the handle towards you.
Reach in carefully with the small needle-nose pliers and firmly grab the golden fastening button.
Step 6
Pulling out the Button
- Once grasping the golden fastening button tightly with small needle-nosed pliers, carefully and slowly pull it out of the handle bar.
- Do not pull out the fastening button rapidly. This may result in the button shooting across the room with great speed.
Once grasping the golden fastening button tightly with small needle-nosed pliers, carefully and slowly pull it out of the handle bar.
Do not pull out the fastening button rapidly. This may result in the button shooting across the room with great speed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Kevin Church
Member since: 10/16/2014
297 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 4-46, Amido Fall 2014
Member of Cal Poly, Team 4-46, Amido Fall 2014
CPSU-AMIDO-F14S4G46
4 Members
8 Guides authored
