Difficulty
Easy
Steps
3
Time Required
5 - 15 minutes
Sections
1
- Back Wheel
- 3 steps
Flags
0
BackJD Razor 2000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unscrewing the Axle Bolt
- Facing the wheelie bar as shown, place your left thumb on the bolt located on the left side of the back wheel and place the Allen wrench into the screw on the right side of the back wheel.
- Using the wrench, slowly unscrew the bolt while applying constant pressure from the left side.
Facing the wheelie bar as shown, place your left thumb on the bolt located on the left side of the back wheel and place the Allen wrench into the screw on the right side of the back wheel.
Using the wrench, slowly unscrew the bolt while applying constant pressure from the left side.
1024
Step 2
Removing the Bolt and Bearing
- Remove the bolt from the right side and the bearing from the left.
Remove the bolt from the right side and the bearing from the left.
Step 3
Removing the Wheel
- Turn the JD Razor 2000 on its side as shown. Slowly remove the back wheel by pulling it out at a perpendicular angle to the scooter base.
Turn the JD Razor 2000 on its side as shown. Slowly remove the back wheel by pulling it out at a perpendicular angle to the scooter base.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Eric Johnson
Member since: 10/17/2014
263 Reputation
1 Guide authored
Badges:
12
+9 more badges
Team
Cal Poly, Team 4-46, Amido Fall 2014
Member of Cal Poly, Team 4-46, Amido Fall 2014
CPSU-AMIDO-F14S4G46
4 Members
8 Guides authored
