Jbl Xtreme 3 Hooks Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 10 minutes

Sections

Exterior Speaker Shell Cover
3 steps
Hooks
1 step

Flags

BackJBL Xtreme 3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Please be careful with the small screws as they are easily lost and pose a choking hazard. This is a fairly easy replacement and only takes a couple of minutes.

What you need

Step 1

              Exterior Speaker Shell Cover

Find the seam on the speaker and position it upwards.
Begin by turning the device to where the bottom side with groves are facing towards you, using the (5) spudger carefully pry open the side of the outer shell where the red indicators are to unlatch outer shell. After they are unlatched you should be able to open the shell by hand.

Find the seam on the speaker and position it upwards.

Begin by turning the device to where the bottom side with groves are facing towards you, using the (5) spudger carefully pry open the side of the outer shell where the red indicators are to unlatch outer shell. After they are unlatched you should be able to open the shell by hand.

1024

Step 2

To continue to remove the outer shell unscrew the two screws (size 1cm) shown in the picture with a size 0 (zero) Phillip’s screwdriver.

To continue to remove the outer shell unscrew the two screws (size 1cm) shown in the picture with a size 0 (zero) Phillip’s screwdriver.

Step 3

To continue to remove the shell use a (5) spudger to slowly pop the shell off.
There is one nudge in the center below the power and bluetooth button that should pop off.
Once you have unlatched this piece correctly the shell will remove itself from the speaker itself. As it is shown in the following figure.

To continue to remove the shell use a (5) spudger to slowly pop the shell off.

There is one nudge in the center below the power and bluetooth button that should pop off.

Once you have unlatched this piece correctly the shell will remove itself from the speaker itself. As it is shown in the following figure.

Step 4

              Hooks

Use a #1 Phillip’s screwdriver to remove the 2 screws on the hook.
Repeat for the second hook, if needed.
Replace the hook, or both if needed.

Use a #1 Phillip’s screwdriver to remove the 2 screws on the hook.

Repeat for the second hook, if needed.

Replace the hook, or both if needed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Maria

Member since: 09/16/2022

351 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Western Carolina University, Team 1-2, Virtue Fall 2022                        

                                                  Member of Western Carolina University, Team 1-2, Virtue Fall 2022 



                    WCU-VIRTUE-F22S1G2                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team