Difficulty
Moderate
Steps
6
Time Required
10 - 20 minutes
Sections
2
- Button Board
- 5 steps
- Outer Casing
- 1 step
Flags
0
BackJBL Pulse
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Button Board
- Use a plastic opening tool to pry around the edges of the circular rubber panel.
Use a plastic opening tool to pry around the edges of the circular rubber panel.
1024
Step 2
- Once the edges are loose, pull off the rubber button panel completely.
- New adhesive will have to be applied when reassembling.
Once the edges are loose, pull off the rubber button panel completely.
New adhesive will have to be applied when reassembling.
Step 3
- Use your plastic opening tool to pry the button board loose by lifting the edges.
Use your plastic opening tool to pry the button board loose by lifting the edges.
Step 4
- Lift the button board, exposing the attached cable.
- New adhesive will have to be applied when reassembling.
Lift the button board, exposing the attached cable.
Step 5
- Pull black piece on top of socket away from board to loosen, then detach the cable.
Pull black piece on top of socket away from board to loosen, then detach the cable.
Step 6
Outer Casing
- Take out the four 9mm black PH0 screws from the top and bottom of the device.
- Pull off cap by hand.
- The outer casing can now be removed.
Take out the four 9mm black PH0 screws from the top and bottom of the device.
Pull off cap by hand.
The outer casing can now be removed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Maxwell Busenbarrick
Member since: 09/15/2016
1,326 Reputation
7 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 18-6, Blackwell Fall 2016
Member of USF Tampa, Team 18-6, Blackwell Fall 2016
USFT-BLACKWELL-F16S18G6
3 Members
7 Guides authored
