Jbl Pulse Led Light Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          25 minutes            

Sections

4

• Button Board
• 5 steps
• Outer Casing
• 1 step
• JBL Pulse LED Lights Disassembly
• 1 step
• LED Light
• 1 step

Flags

0

• BackJBL Pulse

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Button Board               

• Use a plastic opening tool to pry around the edges of the circular rubber panel.

Use a plastic opening tool to pry around the edges of the circular rubber panel.

1024

Step 2

• Once the edges are loose, pull off the rubber button panel completely.
• New adhesive will have to be applied when reassembling.

Once the edges are loose, pull off the rubber button panel completely.

New adhesive will have to be applied when reassembling.

Step 3

• Use your plastic opening tool to pry the button board loose by lifting the edges.

Use your plastic opening tool to pry the button board loose by lifting the edges.

Step 4

• Lift the button board, exposing the attached cable.
• New adhesive will have to be applied when reassembling.

Lift the button board, exposing the attached cable.

Step 5

• Pull black piece on top of socket away from board to loosen, then detach the cable.

Pull black piece on top of socket away from board to loosen, then detach the cable.

Step 6

              Outer Casing               

• Take out the four 9mm black PH0 screws from the top and bottom of the device.
• Pull off cap by hand.
• The outer casing can now be removed.

Take out the four 9mm black PH0 screws from the top and bottom of the device.

Pull off cap by hand.

The outer casing can now be removed.

Step 7

              JBL Pulse LED Lights Disassembly               

• Remove the tape around the cables on the top of the device.
• Remove the cables by lifting up on the black bracket and then pulling the cable out.

Remove the tape around the cables on the top of the device.

Remove the cables by lifting up on the black bracket and then pulling the cable out.

Step 8

              LED Light               

• Pry off LED light panel using a metal spudger.

Pry off LED light panel using a metal spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Maxwell Busenbarrick                     

Member since: 09/15/2016

1,326 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       USF Tampa, Team 18-6, Blackwell Fall 2016                        

                                                  Member of USF Tampa, Team 18-6, Blackwell Fall 2016 



                    USFT-BLACKWELL-F16S18G6                     


                                            3 Members                     


                                            7 Guides authored                     

Jalen6988 - Nov 1, 2017

Reply

Were do I buy a Replacement led strip?