Jbl Pulse 2 Button Circuit Board Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          15 minutes

Sections

Button Circuit Board
8 steps

Flags

BackJBL Pulse 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Button Circuit Board

Remove the rubber rings from either end of the device.
If there is difficulty in lifting the rings from the device, use the metal spudger.

Remove the rubber rings from either end of the device.

If there is difficulty in lifting the rings from the device, use the metal spudger.

1024

Step 2

Remove the four 4.8mm Phillips #1 screws from each end of the device with the Phillips head screwdriver.
Lift the end pieces off of the device.

Remove the four 4.8mm Phillips #1 screws from each end of the device with the Phillips head screwdriver.

Lift the end pieces off of the device.

Step 3

Remove the four 9.5mm Phillips #1 screws from each end of the device.

Remove the four 9.5mm Phillips #1 screws from each end of the device.

Step 4

Peel one end off and slowly draw it across the length of the device until you get to the other side.

Peel one end off and slowly draw it across the length of the device until you get to the other side.

Step 5

Remove the four 7.9mm Phillips #1 screws along the black centerpiece of the device between the camera and the auxiliary port.
Lift up the casing and circuit board but do not try and remove the ribbon wires.

Remove the four 7.9mm Phillips #1 screws along the black centerpiece of the device between the camera and the auxiliary port.

Lift up the casing and circuit board but do not try and remove the ribbon wires.

Step 6

Remove the cover from the end that the ribbon wires are attached to. It should peel off easily.

Remove the cover from the end that the ribbon wires are attached to. It should peel off easily.

Step 7

Unlatch the mechanism holding the ribbon wires in place then disconnect them from the motherboard.
To access the wires, remove some of the black glue holding them in place with the spudger.

Unlatch the mechanism holding the ribbon wires in place then disconnect them from the motherboard.

To access the wires, remove some of the black glue holding them in place with the spudger.

Step 8

Slowly pull the ribbon wires out from the outside.
If there is too much resistance, remove more of the black glue.

Slowly pull the ribbon wires out from the outside.

If there is too much resistance, remove more of the black glue.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Dalton Little

Member since: 08/31/2018

230 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Western Carolina University, Team S1-G1, Virtue Fall 2018                        

                                                  Member of Western Carolina University, Team S1-G1, Virtue Fall 2018 



                    WCU-VIRTUE-F18S1G1                     


                                            4 Members                     


                                            5 Guides authored

Wilco Peters - Aug 8, 2019

where can I buy that part

Davi Dodo - Sep 26, 2019

I love you guys

hernzum - Nov 30, 2022

I need to buy parts

Introduction#

What you need#

Team#

Introduction

What you need

Team