Difficulty
Easy
Steps
9
Time Required
15 - 20 minutes
Sections
2
- Cracking the Case
- 7 steps
- Power Button
- 2 steps
Flags
0
BackJBL On Stage II
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Cracking the Case
- Turn the device upside down so that the three rubber pads are facing up.
Turn the device upside down so that the three rubber pads are facing up.
1024
Step 2
- Use a heat gun (set to low) to apply heat to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.
Use a heat gun (set to low) to apply heat to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.
Step 3
- Remove the heated rubber pad with a plastic opening tool.
- Repeat steps 2 and 3 for the two remaining rubber pads.
Remove the heated rubber pad with a plastic opening tool.
Repeat steps 2 and 3 for the two remaining rubber pads.
Step 4
- Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.
Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.
Step 5
- Open the device along its seam.
- Be careful when separating the device because there are wires connecting the two seperate halves.
Open the device along its seam.
Be careful when separating the device because there are wires connecting the two seperate halves.
Step 6
- Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.
Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.
Step 7
- Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.
Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.
Step 8
Power Button
- Pull the plastic button off the post.
Pull the plastic button off the post.
Step 9
- Remove the metal U-clip (compressing the spring) with tweezers.
Remove the metal U-clip (compressing the spring) with tweezers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Janessa D Cabrera
Member since: 01/23/2014
502 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 9-28, Maness Winter 2014
Member of Cal Poly, Team 9-28, Maness Winter 2014
CPSU-MANESS-W14S9G28
4 Members
7 Guides authored
