Jbl Go Woofer Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          7 - 10 minutes            

Sections

2

• Front Cover
• 3 steps
• Woofer
• 4 steps

Flags

0

• BackJBL Go

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Front Cover               

• Use an opening tool to scrape around the outside of the front cover to remove the glue attaching it to the surrounding rubber layer.

Use an opening tool to scrape around the outside of the front cover to remove the glue attaching it to the surrounding rubber layer.

1024

Step 2

• Once you have scraped off all of the glue, use the opening tool to pry up the front cover.

Once you have scraped off all of the glue, use the opening tool to pry up the front cover.

Step 3

• Carefully remove the loose plastic cover from the speaker.

Carefully remove the loose plastic cover from the speaker.

Step 4

              Woofer               

• Once the front cover is removed, use a T6 screwdriver head to remove the four 9 mm screws on the black cover.

Once the front cover is removed, use a T6 screwdriver head to remove the four 9 mm screws on the black cover.

Step 5

• After removing the screws, use the plastic opening tool to carefully pry around the edges of the black cover to loosen and lift the cover off of the device.

After removing the screws, use the plastic opening tool to carefully pry around the edges of the black cover to loosen and lift the cover off of the device.

Step 6

• Carefully unplug the woofer wires from the motherboard

Carefully unplug the woofer wires from the motherboard

Step 7

• Once the black cover is fully detached from the speaker, unscrew the woofer from the back of the black cover using a T6 screwdriver head.

Once the black cover is fully detached from the speaker, unscrew the woofer from the back of the black cover using a T6 screwdriver head.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Sydney Jason                     

Member since: 03/21/2022

587 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       University of Alabama, Team 2-4, Bedsole Spring 2022                        

                                                  Member of University of Alabama, Team 2-4, Bedsole Spring 2022 



                    UA-BEDSOLE-S22S2G4                     


                                            3 Members                     


                                            4 Guides authored