Difficulty

Moderate

Steps

9

Time Required

                          5 - 10 minutes

Sections

2

  • Front Cover
  • 3 steps
  • Motherboard
  • 6 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackJBL Go

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Cover
  • Use an opening tool to scrape around the outside of the front cover to remove the glue attaching it to the surrounding rubber layer.

Use an opening tool to scrape around the outside of the front cover to remove the glue attaching it to the surrounding rubber layer.

1024

Step 2

  • Once you have scraped off all of the glue, use the opening tool to pry up the front cover.

Once you have scraped off all of the glue, use the opening tool to pry up the front cover.

Step 3

  • Carefully remove the loose plastic cover from the speaker.

Carefully remove the loose plastic cover from the speaker.

Step 4

              Motherboard
  • Once the front cover is removed, use a T6 screwdriver to remove the four 9 mm screws on the black cover.

Once the front cover is removed, use a T6 screwdriver to remove the four 9 mm screws on the black cover.

Step 5

  • After removing the screws, use the plastic opening tool to carefully pry around the edges of the black cover to loosen and lift the cover off of the device.

After removing the screws, use the plastic opening tool to carefully pry around the edges of the black cover to loosen and lift the cover off of the device.

Step 6

  • Carefully unplug the woofer wires from the motherboard.

Carefully unplug the woofer wires from the motherboard.

Step 7

  • Use the T6 screwdriver to remove the 9 mm screw that secures the motherboard in place.

Use the T6 screwdriver to remove the 9 mm screw that secures the motherboard in place.

Step 8

  • Lift the motherboard using the plastic opening tool and stick it through the hole in the middle of the board.

Lift the motherboard using the plastic opening tool and stick it through the hole in the middle of the board.

Step 9

  • Carefully lift the motherboard, sliding the charging port side out of the frame of the speaker as you go.

Carefully lift the motherboard, sliding the charging port side out of the frame of the speaker as you go.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors 


                    Sydney Jason

Member since: 03/21/2022

587 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       University of Alabama, Team 2-4, Bedsole Spring 2022                        

                                                  Member of University of Alabama, Team 2-4, Bedsole Spring 2022 



                    UA-BEDSOLE-S22S2G4                     


                                            3 Members                     


                                            4 Guides authored