Jbl Clip 2 Carabineer Mount Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 15 minutes

Sections

Carabineer Mount
7 steps

Flags

BackJBL Clip 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Carabineer Mount

Begin by removing the front cap of the JBL Clip 2 by using the blue plastic opening tool to get in between the creases.
If your JBL Clip 2 has never been opened this procedure will require moderate amount of force.

Begin by removing the front cap of the JBL Clip 2 by using the blue plastic opening tool to get in between the creases.

If your JBL Clip 2 has never been opened this procedure will require moderate amount of force.

1024

Step 2

There will be six 3 mm T8 screws under the cap, remove these six screws.
If you are not trying to replace the speaker please ignore the two middle 3 mm T8 screws during this procedure.

There will be six 3 mm T8 screws under the cap, remove these six screws.

If you are not trying to replace the speaker please ignore the two middle 3 mm T8 screws during this procedure.

Step 3

The front cover will lift open easily and the components will be visible.

The front cover will lift open easily and the components will be visible.

Step 4

To completely remove the top portion, disconnect the speaker from the motherboard using the blue plastic opening tool.
While disconnecting be sure to not use too much force as these two parts are meant to become disconnected.

To completely remove the top portion, disconnect the speaker from the motherboard using the blue plastic opening tool.

While disconnecting be sure to not use too much force as these two parts are meant to become disconnected.

Step 5

There will be four 3 mm T8 screws holding the motherboard in place, remove these four screws.

There will be four 3 mm T8 screws holding the motherboard in place, remove these four screws.

Step 6

Slightly move the motherboard to the side to reveal the sides of battery, carefully using the blue plastic opening tool, remove the battery from the speaker casing.
Be careful not to disconnect any soldered wires connected to the motherboard and speaker casing.

Slightly move the motherboard to the side to reveal the sides of battery, carefully using the blue plastic opening tool, remove the battery from the speaker casing.

Be careful not to disconnect any soldered wires connected to the motherboard and speaker casing.

Step 7

There are two 3 mm T8 screws holding the carabineer in place, remove these two screws.

There are two 3 mm T8 screws holding the carabineer in place, remove these two screws.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors

                    Michael Hong

Member since: 02/01/2017

1,014 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UW Tacoma, Team 2-2, Rose Winter 2017                        

                                                  Member of UW Tacoma, Team 2-2, Rose Winter 2017 



                    UWT-ROSE-W17S2G2                     


                                            4 Members                     


                                            7 Guides authored

breakdancesok - Aug 2, 2019

i want to find that part ,dou you have web link to by

Daniel - Dec 4, 2019

where can i find this piece please

Introduction#

What you need#

Team#

Introduction

What you need

Team