Jbl Charge 3 Button Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          3 - 5 minutes

Sections

Front Cover
2 steps
Button
2 steps

Flags

BackJBL Charge 3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front Cover

Turn your speaker upside down and insert the plastic opening tool vertically into the slit in the front cover.
Slowly pull the plastic opening tool outward to remove the four clips holding the covering in place.
Repeat this process for all four edges of the front cover.

Turn your speaker upside down and insert the plastic opening tool vertically into the slit in the front cover.

Slowly pull the plastic opening tool outward to remove the four clips holding the covering in place.

Repeat this process for all four edges of the front cover.

1024

Step 2

Pull apart your cover gently from both sides and remove it from the speaker housing.
The inside of the front cover has holes that must match with their corresponding pins on the speaker housing for proper reassembly.
Removing the Front Cover does not affect the waterproof seals of the device. However, removing any further disassembly of your speaker will require removing waterproof seals and gaskets. Your device may no longer be waterproof after these have been altered.

Pull apart your cover gently from both sides and remove it from the speaker housing.

The inside of the front cover has holes that must match with their corresponding pins on the speaker housing for proper reassembly.

Removing the Front Cover does not affect the waterproof seals of the device. However, removing any further disassembly of your speaker will require removing waterproof seals and gaskets. Your device may no longer be waterproof after these have been altered.

Step 3

              Button

Use your plastic opening tool to pry around the edges of the button cover. This will begin to separate the adhesive from the cover.
Peel away the button cover with your hand once you have enough separated from the speaker housing to grab.

Use your plastic opening tool to pry around the edges of the button cover. This will begin to separate the adhesive from the cover.

Peel away the button cover with your hand once you have enough separated from the speaker housing to grab.

Step 4

Flip open the top flap on the ZIF connector.
Gently pull out the ZIF connector cable with tweezers.

Flip open the top flap on the ZIF connector.

Gently pull out the ZIF connector cable with tweezers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      9 other people completed this guide.

Author

                                      with 2 other contributors

                    Sunmin Yoon

Member since: 10/30/2018

1,388 Reputation

                                      2 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team S13-G1, White Fall 2018                        

                                                  Member of Cal Poly, Team S13-G1, White Fall 2018 



                    CPSU-WHITE-F18S13G1                     


                                            3 Members                     


                                            23 Guides authored

D- ASTRO - May 9, 2021

my jbl dont turn on even its in charge it wont turn on

batteries are new but still wont wor

Thomas Bjerregaard - Jan 6, 2023

Where do i buy new buttons?

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team