Difficulty

Difficult

Steps

6

Time Required

                          30 minutes

Sections

1

  • Speaker
  • 6 steps

Flags

2

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackJazz UltraTab C1059-HL

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Speaker
  • Start by removing the back panel.
  • Remove the 4 screws holding the device together: two on the left side, and two on the right side.
  • Using a metal spudger, carefully pry open the case.
  • With the screws gone, the case is held together with clips along the outside edge of the aluminum backplate.
  • Undoing these clips can take a bit of force. Be cautious not to damage the plastic edge of the device.

Start by removing the back panel.

Remove the 4 screws holding the device together: two on the left side, and two on the right side.

Using a metal spudger, carefully pry open the case.

With the screws gone, the case is held together with clips along the outside edge of the aluminum backplate.

Undoing these clips can take a bit of force. Be cautious not to damage the plastic edge of the device.

1024

Step 2

  • Place the device on the table with the screen-side down.

Place the device on the table with the screen-side down.

Step 3

  • This is the Speaker.
  • Remove the two black screws.

This is the Speaker.

Remove the two black screws.

Step 4

  • Remove black tape from the wires.
  • Keep this tape, you will need it for reassembly.

Remove black tape from the wires.

Keep this tape, you will need it for reassembly.

Step 5

  • Using a soldering iron, heat up the spot where the speaker wires connect to the mainboard.
  • Remove Speaker wires when the solder liquifies.
  • Remember to make note of where each wire is connected. When reinstalling the speaker, it is important that the wires are reattached to the same spot.

Using a soldering iron, heat up the spot where the speaker wires connect to the mainboard.

Remove Speaker wires when the solder liquifies.

Remember to make note of where each wire is connected. When reinstalling the speaker, it is important that the wires are reattached to the same spot.

Step 6

  • Remove the speaker.
  • Replace the speaker by following these steps in reverse.

Remove the speaker.

Replace the speaker by following these steps in reverse.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Tim Poe

Member since: 09/26/2015

361 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       IUPUI, Team 1-3, Wilson Fall 2015                        

                                                  Member of IUPUI, Team 1-3, Wilson Fall 2015 



                    IUPUI-WILSON-F15S1G3                     


                                            4 Members                     


                                            6 Guides authored