Jawbone Mini Jambox Outer Case Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Outer Case
5 steps

Flags

BackJawbone MINI JAMBOX
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Outer Case

Using the standard metal spudger, begin by prying at the bottom of the plain rubber end cap (the end without the USB or auxiliary input).

Using the standard metal spudger, begin by prying at the bottom of the plain rubber end cap (the end without the USB or auxiliary input).

1024

Step 2

Continue prying around the end panel, prying at different points until the entire panel is out of its seating.
Carefully remove the end panel.
The tabs which connect the panel are on the short sides.
WARNING: you will likely cause cosmetic damage to the end cap.

Continue prying around the end panel, prying at different points until the entire panel is out of its seating.

Carefully remove the end panel.

The tabs which connect the panel are on the short sides.

WARNING: you will likely cause cosmetic damage to the end cap.

Step 3

Slide out the rubber foot located on the bottom of the case.

Slide out the rubber foot located on the bottom of the case.

Step 4

Using a T6 bit, remove the flat topped 5mm screw located on the bottom of the casing, underneath the rubber foot.
This is the only flat topped screw in the speaker, so keep track of which one it is.

Using a T6 bit, remove the flat topped 5mm screw located on the bottom of the casing, underneath the rubber foot.

This is the only flat topped screw in the speaker, so keep track of which one it is.

Step 5

Push against the side without end cap to slide the internal components out of the case.
While holding the metal outset casing with one hand, press on the black inner plastic casing with your thumb.
It will be very difficult the first time. There is a rubber seal on the outside of the plastic inner case that creates a lot of friction with the metal outer case.

Push against the side without end cap to slide the internal components out of the case.

While holding the metal outset casing with one hand, press on the black inner plastic casing with your thumb.

It will be very difficult the first time. There is a rubber seal on the outside of the plastic inner case that creates a lot of friction with the metal outer case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Noah Sadler

Member since: 04/01/2015

548 Reputation

                                      2 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       Cal Poly, Team 12-1, Lancaster Spring 2015                        

                                                  Member of Cal Poly, Team 12-1, Lancaster Spring 2015 



                    CPSU-LANCASTER-S15S12G1                     


                                            5 Members                     


                                            10 Guides authored

aric.valliere - Jul 5, 2018

Does anyone know where to find replacement outer shells for the big jambox?

Introduction#

What you need#

Team#

Introduction

What you need

Team