Difficulty

Moderate

Steps

8

Time Required

                          15 - 20 minutes

Sections

3

  • Hard Mesh Cover
  • 1 step
  • Motherboard
  • 6 steps
  • Speaker
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackJam Voice

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Hard Mesh Cover
  • Insert the plastic opening tool underneath the mesh top.
  • Pry the cover open.
  • To reattach the cover, simply align the round posts on the bottom of the cover into the holes.

Insert the plastic opening tool underneath the mesh top.

Pry the cover open.

To reattach the cover, simply align the round posts on the bottom of the cover into the holes.

1024

Step 2

              Motherboard
  • Remove the four 7mm Phillips screws from the plastic cover.

Remove the four 7mm Phillips screws from the plastic cover.

Step 3

  • Remove the four 5mm Phillips screws that hold down the speaker in place.
  • Remove the two 6mm Phillips screws that hold down the plastic casing.

Remove the four 5mm Phillips screws that hold down the speaker in place.

Remove the two 6mm Phillips screws that hold down the plastic casing.

Step 4

  • Once all six screws are removed, use a Halberd Spudger or similar tool to lift up the speaker.
  • Pull the speaker up and out.

Once all six screws are removed, use a Halberd Spudger or similar tool to lift up the speaker.

Pull the speaker up and out.

Step 5

  • Remove the four 7mm Phillips screws to expose the motherboard.

Remove the four 7mm Phillips screws to expose the motherboard.

Step 6

  • After removing all of the screws from the plastic cover, remove it by pulling up and out.
  • Be careful not to pull and damage any of the wires.

After removing all of the screws from the plastic cover, remove it by pulling up and out.

Be careful not to pull and damage any of the wires.

Step 7

  • Remove the three 5mm Phillips screws that hold the motherboard in place.
  • After the screws are removed, place two fingers on the power button and Bluetooth button to push the motherboard out.

Remove the three 5mm Phillips screws that hold the motherboard in place.

After the screws are removed, place two fingers on the power button and Bluetooth button to push the motherboard out.

Step 8

              Speaker
  • Use tweezers to pull out the speaker’s wire from the motherboard.
  • Use tweezers to pull out the battery’s wire from the motherboard.
  • The speaker’s connection point is opposite the battery’s connection point.

Use tweezers to pull out the speaker’s wire from the motherboard.

Use tweezers to pull out the battery’s wire from the motherboard.

The speaker’s connection point is opposite the battery’s connection point.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Alexander Buck

Member since: 04/05/2018

358 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges