Difficulty

Moderate

Steps

4

Time Required

Suggest a time??

Sections

1

  • Power Port
  • 4 steps

Flags

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackJadoo 3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Hello Electronic Lovers, in this tutorial I will show you how to repair a broken Power port of the JADOO box. You can Replace a Power Port or by connecting charger wires directly to the main circuit. We need 5v DC output from the charger or power supply to run JADOO box. I will recommend to change a Port instead of connecting wires directly.

What you need

Step 1

              Power Port
  • The box back cover doesn’t not has screw, just use any sharp thing, knife, in the edge of the box and pull the sharp thing , knife, a cover will be popped up and take out The circuit Board carefully.

The box back cover doesn’t not has screw, just use any sharp thing, knife, in the edge of the box and pull the sharp thing , knife, a cover will be popped up and take out The circuit Board carefully.

1024

Step 2

  • Cut the power cable and peel the wire and 2 wire should be appear black and red as shown in picture

Cut the power cable and peel the wire and 2 wire should be appear black and red as shown in picture

Step 3

  • Black wire will be connected to the first point on the right side and Red wire will be the first point on left side of the board. If in case doesn’t work the change the step to the opposite.If board lights on its mean wire should be solder with the board.

Black wire will be connected to the first point on the right side and Red wire will be the first point on left side of the board. If in case doesn’t work the change the step to the opposite.If board lights on its mean wire should be solder with the board.

Step 4

  • For the safety of wire melt the glue stick on wire with board to safe from moving

For the safety of wire melt the glue stick on wire with board to safe from moving

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    The Mariocrafter

Member since: 05/16/2020

1,506 Reputation

                                      9 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges