Difficulty
Very difficult
Steps
8
Time Required
15 - 45 minutes
Sections
2
- Front Panel
- 3 steps
- Battery
- 5 steps
Flags
0
BackJabra Freeway
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Panel
- Turn off the device before proceeding. Failure to do so may result in device damage or injury to oneself.
- Remove the rubber pads from the bottom of the device using the spudger.
Turn off the device before proceeding. Failure to do so may result in device damage or injury to oneself.
Remove the rubber pads from the bottom of the device using the spudger.
1024
Step 2
- Remove the eight 6mm T9 screws.
- Two of these screws are underneath the foam padding. This padding is glued on and will be destroyed in this process. Poking through the foam minimizes the damage to the device.
Remove the eight 6mm T9 screws.
Two of these screws are underneath the foam padding. This padding is glued on and will be destroyed in this process. Poking through the foam minimizes the damage to the device.
Step 3
- Gently lift the front panel off of the device and carefully rest it to the side.
Gently lift the front panel off of the device and carefully rest it to the side.
Step 4
Battery
- Remove the rubber gasket using tweezers.
Remove the rubber gasket using tweezers.
Step 5
- Remove the five 6mm T6 screws connecting the circuit board to the rear panel.
Remove the five 6mm T6 screws connecting the circuit board to the rear panel.
Step 6
- Remove the microphone from microphone slot.
Remove the microphone from microphone slot.
Step 7
- Carefully use the plastic opening tool to lift the circuit board up.
Carefully use the plastic opening tool to lift the circuit board up.
Step 8
- Desolder the three wires connecting the battery.
- Please refer to the soldering technique guide for instructions on desoldering and soldering.
Desolder the three wires connecting the battery.
Please refer to the soldering technique guide for instructions on desoldering and soldering.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 2 other contributors
Alec Wilson
Member since: 10/19/2016
714 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team 4-8, Catania Fall 2016
Member of UMass Dartmouth, Team 4-8, Catania Fall 2016
UMASSD-CATANIA-F16S4G8
2 Members
6 Guides authored
Glenn C - Jan 18, 2017
Reply
Hey Alec,
Why does your guide to replacing the battery in the Jabra Freeway say “no parts required”?
This would be much more useful if you provide a part number and source(s) for the replacement battery. And then maybe show removing the old battery and installing the new one.
Devesh Singh Senwal - Sep 26, 2017
Reply
Hi,
Does anyone knows a source for the compatible battery. Since Jabra Freeway battery has 3 wires, cannot find it online. I could find compatible batteries from China websites but they were with 2 wires.
scuba - Mar 30, 2018
Reply
I am sourcing replacement batteries for the jabra freeway should be in the end of april
chcastle - May 10, 2018
Reply
any luck finding a replacement battery yet for this device???
DavidNS - Jun 5, 2018
Reply
I’m looking for the batteries, 3 of them, right now 2018 06.