Iview 754Tpc Battery Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

Suggest a time??

Sections

Rear Panel
1 step
Remove Battery
1 step
Battery
1 step

Flags

BackiVIEW-754TPC
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Rear Panel

Before disassembling your tablet, make sure it is powered off.
Use plastic opening tool to release the clips holding the device together. The clips will take a small amount of pressure to release. Once you have the plastic opening tool inserted, use a twisting action to release the clips. Start from bottom of device and work all the way around.

Before disassembling your tablet, make sure it is powered off.

Use plastic opening tool to release the clips holding the device together. The clips will take a small amount of pressure to release. Once you have the plastic opening tool inserted, use a twisting action to release the clips. Start from bottom of device and work all the way around.

1024

Step 2

              Remove Battery

Use flat side of the spudger to get under battery and use pressure to release from glue. Do this all the way around battery until it comes off.
At this point do not attempt to fully remove the battery as it is still attached to the logic board.

Use flat side of the spudger to get under battery and use pressure to release from glue. Do this all the way around battery until it comes off.

At this point do not attempt to fully remove the battery as it is still attached to the logic board.

Step 3

              Desolder wires

Once battery is off, the wires will still be connected to motherboard. You will need to desolder the wires.
Using the soldering tool, use the heat to melt the connection. As you do this, pull on the wires with a tweezer until wires comes off.
To ease reassembly, take note of which wire goes to the negative and positive terminals.

Once battery is off, the wires will still be connected to motherboard. You will need to desolder the wires.

Using the soldering tool, use the heat to melt the connection. As you do this, pull on the wires with a tweezer until wires comes off.

To ease reassembly, take note of which wire goes to the negative and positive terminals.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors

                    calvin

Member since: 01/21/2015

188 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 5-4, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 5-4, Brown Winter 2015 



                    USFT-BROWN-W15S5G4                     


                                            4 Members                     


                                            16 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team