Ivation Ivwpdc20Y Display Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          20 minutes            

Sections

1

• Display
• 7 steps

Flags

0

• BackIvation IVWPDC20Y

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Display               

• With the H2.0 bit screwdriver, remove the two screws on the yellow waterproof cover

With the H2.0 bit screwdriver, remove the two screws on the yellow waterproof cover

1024

Step 2

• Apply a plastic opening tool to each of the corners and gently remove the casing
• The front casing is held down by adhesive and may require additional work to remove
• Apply just enough force to undo the inner latches to make sure not to damage the waterproof seal

Apply a plastic opening tool to each of the corners and gently remove the casing

The front casing is held down by adhesive and may require additional work to remove

Apply just enough force to undo the inner latches to make sure not to damage the waterproof seal

Step 3

• Remove the five silver screws from the inner casing using the PH00 screwdriver bit.

Remove the five silver screws from the inner casing using the PH00 screwdriver bit.

Step 4

• Remove the six screws from the edge of the clear inner casing with the PH00 screwdriver bit.
• These screws are very small and easy to strip so apply consistent pressure when removing them

Remove the six screws from the edge of the clear inner casing with the PH00 screwdriver bit.

These screws are very small and easy to strip so apply consistent pressure when removing them

Step 5

• Pry off back outer casing using the black spudger or the blue prying tools.

Pry off back outer casing using the black spudger or the blue prying tools.

Step 6

• Carefully remove the screen from the silver casing using a prying tool or the black spudger.
• There is adhesive in the center of the screen, be sure not to bend it when applying pressure.

Carefully remove the screen from the silver casing using a prying tool or the black spudger.

There is adhesive in the center of the screen, be sure not to bend it when applying pressure.

Step 7

• Using the poker end of the spudger push gently on the black pegs holding the orange tape in place.
• Screen and orange tape should slip out as a whole.

Using the poker end of the spudger push gently on the black pegs holding the orange tape in place.

Screen and orange tape should slip out as a whole.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Alex                     

Member since: 02/08/2016

228 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       USF Tampa, Team 6-6, Eyestone Spring 2016                        

                                                  Member of USF Tampa, Team 6-6, Eyestone Spring 2016 



                    USFT-EYESTONE-S16S6G6                     


                                            3 Members                     


                                            5 Guides authored