Difficulty

Difficult

Steps

8

Time Required

                          5 minutes

Sections

2

  • Battery
  • 5 steps
  • Camera
  • 3 steps

Flags

0

  • BackiRulu AX760

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a plastic opening tool or metal spudger to free the rear cover.
  • Insert your spudger into the side of your tablet.
  • Crack open each edge and remove the cover.

Use a plastic opening tool or metal spudger to free the rear cover.

Insert your spudger into the side of your tablet.

Crack open each edge and remove the cover.

1024

Step 2

  • Open your tablet.

Open your tablet.

Step 3

  • Take your plastic flat head tool and insert it under the battery.
  • Lift the battery up.
  • Make sure to remove any tape from the battery.

Take your plastic flat head tool and insert it under the battery.

Lift the battery up.

Make sure to remove any tape from the battery.

Step 4

  • Use a soldering iron to remove the solder that connects the black and red wires of the battery to the motherboard.
  • Keep the wires of the battery taught.
  • The iron should only be pressed to the solder for 2-3 seconds max.
  • Be very carful, the soldering iron will be very hot!
  • Visit this link for information about soldering. How To Solder and Desolder Connections

Use a soldering iron to remove the solder that connects the black and red wires of the battery to the motherboard.

Keep the wires of the battery taught.

The iron should only be pressed to the solder for 2-3 seconds max.

Be very carful, the soldering iron will be very hot!

Visit this link for information about soldering. How To Solder and Desolder Connections

Step 5

  • Remove your old battery and replace it with the new battery.

Remove your old battery and replace it with the new battery.

Step 6

              Camera
  • Use the plastic spudger to pry the tabs open on the digitizer ribbon sockets.

Use the plastic spudger to pry the tabs open on the digitizer ribbon sockets.

Step 7

  • Pull the digitizer ribbon cables straight out of their sockets.

Pull the digitizer ribbon cables straight out of their sockets.

Step 8

  • Pull the camera out of the device.

Pull the camera out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jamison Kritz

Member since: 03/20/2018

218 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       IUPUI, Team S6-G4, Baechle Spring 2018                        

                                                  Member of IUPUI, Team S6-G4, Baechle Spring 2018 



                    IUPUI-BAECHLE-S18S6G4                     


                                            4 Members                     


                                            8 Guides authored