Irobot Roomba E5 Maintenance Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 20 minutes

Sections

Two middle brushes, Edge Sweeping Brush and Dust Bin
5 steps

Flags

BackiRobot Roomba e5
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

This guide illustrates how to replace the iRobot Roomba e5 (5134) Wi-Fi Connected Robot Vacuum: Edge Sweeping Brush, two Multi-Surface Brushes and the Dust Bin filter.

Before beginning, make sure you have a wide and flat space (preferably a wide table) that can get dirty. When disassembling some parts it is very likely dust and dirt will fall off from the vacuum, particularly in Step 3.

What you need

Step 1

              Two middle brushes, Edge Sweeping Brush and Dust Bin

To remove the edge sweeping brush, use a Phillips #0 screwdriver to remove the 8 mm screw holding it in place.

To remove the edge sweeping brush, use a Phillips #0 screwdriver to remove the 8 mm screw holding it in place.

1024

Step 2

To remove the two multi-surface brushes, lift the adjacent piece by pressing down the green lever and pulling it up.
Then remove the brushes by lifting them by the right side.

To remove the two multi-surface brushes, lift the adjacent piece by pressing down the green lever and pulling it up.

Then remove the brushes by lifting them by the right side.

Step 3

To remove the dust bin, press down on the button with a “trash bin” drawing by the side of the vacuum.
While pressing the button, gently pull the dust bin out.
When removing the dust bin, dust can tip over the surface and create a mess.

To remove the dust bin, press down on the button with a “trash bin” drawing by the side of the vacuum.

While pressing the button, gently pull the dust bin out.

When removing the dust bin, dust can tip over the surface and create a mess.

Step 4

To remove the filter located at the right side of the dust bin, press the filter on top and at the bottom and pull.

To remove the filter located at the right side of the dust bin, press the filter on top and at the bottom and pull.

Step 5

Clean every part of the vacuum thoroughly with a dust rag or paper towel and Q-tip.

Clean every part of the vacuum thoroughly with a dust rag or paper towel and Q-tip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Fabiola Velez

Member since: 03/18/2022

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of Puerto Rico Mayagüez, Team 2-24, Cools Stephens Spring 2022                        

                                                  Member of University of Puerto Rico Mayagüez, Team 2-24, Cools Stephens Spring 2022 



                    UPRM-COOLS STEPHENS-S22S2G24                     


                                            1 Member                     


                                            1 Guide authored

Introduction#

What you need#

Team#

Introduction

What you need

Team