Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

1

  • Cleaning Head
  • 6 steps

Flags

0

  • BackiRobot Roomba 880

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cleaning Head
  • Flip the Roomba over, wheel-side up.
  • Using a Phillips #1 screwdriver, loosen the four 15 mm screws illustrated. Two are located on the battery door, while two are on the bottom panel.
  • Remove the battery door, pulling straight up from the two indents above the screws.

Flip the Roomba over, wheel-side up.

Using a Phillips #1 screwdriver, loosen the four 15 mm screws illustrated. Two are located on the battery door, while two are on the bottom panel.

Remove the battery door, pulling straight up from the two indents above the screws.

1024

Step 2

              Side Brush
  • Using a flat head screwdriver, loosen the screw on the top of the side brush.
  • Remove side brush.
  • The bottom panel cannot be removed without first removing the side brush, so make sure to do this first.

Using a flat head screwdriver, loosen the screw on the top of the side brush.

Remove side brush.

The bottom panel cannot be removed without first removing the side brush, so make sure to do this first.

Step 3

              Bottom Panel
  • Pull up on the bottom panel to remove.

Pull up on the bottom panel to remove.

Step 4

              Dust Bin
  • Reach underneath the dust bin, press the bin removal button, and pull out.
  • The bin removal button is located on the top edge of the bin.

Reach underneath the dust bin, press the bin removal button, and pull out.

The bin removal button is located on the top edge of the bin.

Step 5

  • Using a Phillips #1 screwdriver, remove the four 10 mm screws shown.

Using a Phillips #1 screwdriver, remove the four 10 mm screws shown.

Step 6

              Remove Cleaning Head
  • Remove the cleaning head by grabbing the two protruding tabs as shown, and pulling straight up.

Remove the cleaning head by grabbing the two protruding tabs as shown, and pulling straight up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Allie Ahern

Member since: 04/27/2017

130 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Cal Poly, Team S17-G4, Banghart Spring 2017                        

                                                  Member of Cal Poly, Team S17-G4, Banghart Spring 2017 



                    CPSU-BANGHART-S17S17G4                     


                                            5 Members                     


                                            5 Guides authored