Difficulty
Easy
Steps
3
Time Required
55 seconds
Sections
1
- Side Brush
- 3 steps
Flags
0
BackiRobot Roomba 860
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Side Brush
- Start by locating the yellow side brush on the underside of the iRobot Roomba 860 near the front of the device.
Start by locating the yellow side brush on the underside of the iRobot Roomba 860 near the front of the device.
1024
Step 2
- Using a Philips #2 Point Screwdriver, remove the screw located in the center of the brush.
Using a Philips #2 Point Screwdriver, remove the screw located in the center of the brush.
Step 3
- Pull up on the side brush and it should slide off, free of the motor shaft.
- Remove any debris that could be preventing the side brush from spinning and/or replace the side brush.
Pull up on the side brush and it should slide off, free of the motor shaft.
Remove any debris that could be preventing the side brush from spinning and/or replace the side brush.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Ryan Murphy
Member since: 03/02/2017
446 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S13-G5, Cagle Spring 2017
Member of USF Tampa, Team S13-G5, Cagle Spring 2017
USFT-CAGLE-S17S13G5
4 Members
4 Guides authored
Linda - May 26, 2019
Reply
What to do if the screw head is broken off? Thanks
