Irobot Roomba 770 Side Brush Motor Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Battery
2 steps
Side Brush Motor
3 steps

Flags

BackiRobot Roomba 770
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Flip the Roomba over so that the wheels are facing up and the dust tray is closest to you.
Using the J1 Phillips screwdriver, locate and unscrew the two 11mm phillips screws above the brushes on the battery panel.
Remove the plastic plate from the battery box.

Flip the Roomba over so that the wheels are facing up and the dust tray is closest to you.

Using the J1 Phillips screwdriver, locate and unscrew the two 11mm phillips screws above the brushes on the battery panel.

Remove the plastic plate from the battery box.

1024

Step 2

Locate the 2 green tabs on the left and right of the big yellow battery.
Grab the tabs with your hands and lift straight upward.

Locate the 2 green tabs on the left and right of the big yellow battery.

Grab the tabs with your hands and lift straight upward.

Step 3

              Side Brush Motor

Using the J1 Philips Screwdriver, remove the 15.5 mm screw located in the center of the side brush.
Remove the brush by pulling upwards.
Do not lean directly over the brush when attempting to remove. Removing the brush requires a firm pull and may release suddenly.

Using the J1 Philips Screwdriver, remove the 15.5 mm screw located in the center of the side brush.

Remove the brush by pulling upwards.

Do not lean directly over the brush when attempting to remove. Removing the brush requires a firm pull and may release suddenly.

Step 4

Using the J1 Philips Screwdriver, remove the two 15.5 mm screws located on the bottom of the plate covering the bottom of the roomba.
Lift upwards to remove the bottom plate.

Using the J1 Philips Screwdriver, remove the two 15.5 mm screws located on the bottom of the plate covering the bottom of the roomba.

Lift upwards to remove the bottom plate.

Step 5

Using the J1 Philips Screwdriver, remove the two gold 15.5 mm screws located on the blue plastic module the side brush had previously been attached too.
Lift the blue module upwards. The module contains the motor for the side brush.

Using the J1 Philips Screwdriver, remove the two gold 15.5 mm screws located on the blue plastic module the side brush had previously been attached too.

Lift the blue module upwards. The module contains the motor for the side brush.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Ashley Woods

Member since: 10/06/2016

347 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 15-3, Livingston Fall 2016                        

                                                  Member of Cal Poly, Team 15-3, Livingston Fall 2016 



                    CPSU-LIVINGSTON-F16S15G3                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team