Difficulty

Moderate

Steps

5

Time Required

                          15 - 30 minutes

Sections

3

  • Front Face Plate
  • 2 steps
  • Front Bumper
  • 2 steps
  • Internal Faceplate
  • 1 step

Flags

0

  • BackiRobot Roomba 655 Pet Series

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Face Plate
  • Remove the dust bin by pushing on the button for the dust bin removal
  • Pull the dust bin out

Remove the dust bin by pushing on the button for the dust bin removal

Pull the dust bin out

1024

Step 2

  • Pull up on the silver handle to release the top protectant plastic
  • Remove the top plastic carefully

Pull up on the silver handle to release the top protectant plastic

Remove the top plastic carefully

Step 3

              Front Bumper
  • Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.
  • Pull the plastic bumper protector up and off of the bumper.

Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.

Pull the plastic bumper protector up and off of the bumper.

Step 4

  • Flip the Roomba back over, so you are viewing the top.
  • Pull up on the front bumper to remove it.
  • Be careful not to pull too hard because there is wiring attached to the bumper.
  • Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.

Flip the Roomba back over, so you are viewing the top.

Pull up on the front bumper to remove it.

Be careful not to pull too hard because there is wiring attached to the bumper.

Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.

Step 5

              Internal Faceplate
  • The outside six - 10mm screws and the inside set of four - 10mm screws are the same here, use your Phillips head #2 to remove them
  • Use your Phillips head #0 to remove the one - 7mm bottom center screw
  • Use your Phillips head #2 to remove the two - 8mm screws by the handle
  • Push down the two release points to pull the plastic piece up
  • Pull the plastic piece up

The outside six - 10mm screws and the inside set of four - 10mm screws are the same here, use your Phillips head #2 to remove them

Use your Phillips head #0 to remove the one - 7mm bottom center screw

Use your Phillips head #2 to remove the two - 8mm screws by the handle

Push down the two release points to pull the plastic piece up

Pull the plastic piece up

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Rhett

Member since: 01/22/2015

1,310 Reputation

                                      7 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       Cal Poly, Team 21-20, Maness Winter 2015                        

                                                  Member of Cal Poly, Team 21-20, Maness Winter 2015 



                    CPSU-MANESS-W15S21G20                     


                                            4 Members                     


                                            14 Guides authored