Difficulty
Moderate
Steps
2
Time Required
15 - 30 minutes
Sections
1
- Front Bumper
- 2 steps
Flags
0
BackiRobot Roomba 655 Pet Series
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Bumper
- Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.
- Pull the plastic bumper protector up and off of the bumper.
Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.
Pull the plastic bumper protector up and off of the bumper.
1024
Step 2
- Flip the Roomba back over, so you are viewing the top.
- Pull up on the front bumper to remove it.
- Be careful not to pull too hard because there is wiring attached to the bumper.
- Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.
Flip the Roomba back over, so you are viewing the top.
Pull up on the front bumper to remove it.
Be careful not to pull too hard because there is wiring attached to the bumper.
Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 7 other contributors
Rhett
Member since: 01/22/2015
1,310 Reputation
7 Guides authored
Badges:
18
+15 more badges
Team
Cal Poly, Team 21-20, Maness Winter 2015
Member of Cal Poly, Team 21-20, Maness Winter 2015
CPSU-MANESS-W15S21G20
4 Members
14 Guides authored
