Difficulty

Easy

Steps

5

Time Required

                          10 - 15 minutes

Sections

1

  • Fan
  • 5 steps

Flags

0

  • BackiRobot Roomba 560

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Fan
  • Press the black circular button on the back end of the Roomba and pull the bin out towards you to remove the vacuum bin.

Press the black circular button on the back end of the Roomba and pull the bin out towards you to remove the vacuum bin.

1024

Step 2

  • Lay the vacuum bin down and remove the six 15 mm screws around the outside of the vacuum bin using the Phillips JIS #1 driver.
  • Remove the top of the vacuum bin by pulling it straight up.
  • The bin is composed of two parts (the clear top casing and the red bottom filter). To avoid a mess, be careful to not let these two pieces detach, unless over a trash bin.

Lay the vacuum bin down and remove the six 15 mm screws around the outside of the vacuum bin using the Phillips JIS #1 driver.

Remove the top of the vacuum bin by pulling it straight up.

The bin is composed of two parts (the clear top casing and the red bottom filter). To avoid a mess, be careful to not let these two pieces detach, unless over a trash bin.

Step 3

  • Remove the three 10 mm screws that surround the fan using the Phillips JIS #1 driver.
  • Remove the casing that surrounds the fan by pulling it straight up.
  • The casing is composed of 2 parts (the large top casing, and a small air filter). If these parts detach, they are very easy to put back together. Do not lose the air filter.

Remove the three 10 mm screws that surround the fan using the Phillips JIS #1 driver.

Remove the casing that surrounds the fan by pulling it straight up.

The casing is composed of 2 parts (the large top casing, and a small air filter). If these parts detach, they are very easy to put back together. Do not lose the air filter.

Step 4

  • Turn over the remainder of the fan casing and remove the single 15mm screw, using the Phillips JIS #1 screwdriver.
  • Remove the casing from the fan and battery component by pulling it straight up.

Turn over the remainder of the fan casing and remove the single 15mm screw, using the Phillips JIS #1 screwdriver.

Remove the casing from the fan and battery component by pulling it straight up.

Step 5

  • Remove the small black button from the top of the battery.
  • Save the spring and the button cover. The remainder of the fan assembly (yellow motor and the black housing) will need to be replaced as a unit.

Remove the small black button from the top of the battery.

Save the spring and the button cover. The remainder of the fan assembly (yellow motor and the black housing) will need to be replaced as a unit.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    TJ Tamura

Member since: 10/01/2015

268 Reputation

                                      1 Guide authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 1-22, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 1-22, Maness Fall 2015 



                    CPSU-MANESS-F15S1G22                     


                                            4 Members                     


                                            14 Guides authored