Irobot Braava 320 Body Shell Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          2 - 5 minutes

Sections

Battery
3 steps
Body Shell and Control Panel
2 steps

Flags

BackiRobot Braava 320
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Flip your device over and locate the battery cover.
The battery cover is located in the center of the device in between both wheels.

Flip your device over and locate the battery cover.

The battery cover is located in the center of the device in between both wheels.

1024

Step 2

Using a Flathead #4 screwdriver, gently turn the 12mm screw that holds the battery cover in.
The screw does not remove, it stays attached to the cover.

Using a Flathead #4 screwdriver, gently turn the 12mm screw that holds the battery cover in.

The screw does not remove, it stays attached to the cover.

Step 3

Gently remove the battery from the tray and disconnect the battery cable.
To remove the battery, pull it straight up. To disconnect the cable, gently pull it straight out of the connector.
To reinstall the cable, hold it near the end and gently push it in the connector.

Gently remove the battery from the tray and disconnect the battery cable.

To remove the battery, pull it straight up. To disconnect the cable, gently pull it straight out of the connector.

To reinstall the cable, hold it near the end and gently push it in the connector.

Step 4

              Body Shell and Control Panel

With the battery removed, rotate your device so the front of it is facing you.
Remove the four 10mm Phillips #2 screws that attach the shell.

With the battery removed, rotate your device so the front of it is facing you.

Remove the four 10mm Phillips #2 screws that attach the shell.

Step 5

Using both hands, hold the device together while you flip it over.
Starting from the front, gently lift up the shell and slowly tilt back until it is fully removed.

Using both hands, hold the device together while you flip it over.

Starting from the front, gently lift up the shell and slowly tilt back until it is fully removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Adam Lewis

Member since: 02/28/2017

214 Reputation

                                      1 Guide authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team S1-G3, Nance Spring 2017                        

                                                  Member of USF Tampa, Team S1-G3, Nance Spring 2017 



                    USFT-NANCE-S17S1G3                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team