Iq America Vd 8810L Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Motherboard
9 steps

Flags

BackIQ America VD-8810
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Motherboard

Wedge the spudger into the slot of the panel on the bottom of the device.
Rotate out the panel to reveal the screw holding the device together.

Wedge the spudger into the slot of the panel on the bottom of the device.

Rotate out the panel to reveal the screw holding the device together.

1024

Step 2

Use the Phillips head screwdriver to remove the screw.
Separate the Top and bottom halves of the device.

Use the Phillips head screwdriver to remove the screw.

Separate the Top and bottom halves of the device.

Step 3

Remove batteries from the battery slot.
Unscrew the two Phillips head screws in the center of the battery slot.
Unscrew the remaining two screws at the bottom of the unit using the 3.0 triangle head screwdriver.

Remove batteries from the battery slot.

Unscrew the two Phillips head screws in the center of the battery slot.

Unscrew the remaining two screws at the bottom of the unit using the 3.0 triangle head screwdriver.

Step 4

Use the spudger to separate the top and bottom halves of the screen.

Use the spudger to separate the top and bottom halves of the screen.

Step 5

Disconnect the wires from the green motherboard to the bottom half by pulling apart the connecting pins.

Disconnect the wires from the green motherboard to the bottom half by pulling apart the connecting pins.

Step 6

Unscrew all 3 Phillips head screws on the outside edges of the motherboard.

Unscrew all 3 Phillips head screws on the outside edges of the motherboard.

Step 7

Carefully remove the microphone from the casing by pulling away from the device.

Carefully remove the microphone from the casing by pulling away from the device.

Step 8

Gently lift the motherboard from the casing to reveal the speaker.
Unscrew the two Phillips head screws that hold the speaker in place.

Gently lift the motherboard from the casing to reveal the speaker.

Unscrew the two Phillips head screws that hold the speaker in place.

Step 9

Refer to this guide to desolder the speaker from the motherboard.

Refer to this guide to desolder the speaker from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Jackey Lau

Member since: 10/17/2017

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UC Santa Barbara, Team S1-G3, Weedon Fall 2017                        

                                                  Member of UC Santa Barbara, Team S1-G3, Weedon Fall 2017 



                    UCSB-WEEDON-F17S1G3                     


                                            5 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team