Ipod Shuffle 3Rd Generation Logic Board Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          15 minutes            

Sections

2

• Rear Case
• 4 steps
• Logic Board
• 3 steps

Flags

0

• BackiPod Shuffle 3rd Generation

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rear Case               

• Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
• Be careful when using a metal spudger, as you may scratch the outer case.

Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.

Be careful when using a metal spudger, as you may scratch the outer case.

1024

Step 2

• Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.

Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.

Step 3

• Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.
• Pry the rear case away from the front case.

Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.

Pry the rear case away from the front case.

Step 4

• Lift the bottom of the rear case and remove it from the rest of the iPod.

Lift the bottom of the rear case and remove it from the rest of the iPod.

Step 5

              Logic Board               

• Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.

Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.

Step 6

• Remove the single Phillips screw securing the logic board to the front case.

Remove the single Phillips screw securing the logic board to the front case.

Step 7

• Peel the battery up from the front case with an iPod opening tool.
• Remove the logic board and battery from the iPod.

Peel the battery up from the front case with an iPod opening tool.

Remove the logic board and battery from the iPod.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Matthew Newsom                     

Member since: 01/05/2010

37,896 Reputation

                                      67 Guides authored                  



                       Badges:
                       47







                                                        +44 more badges