Difficulty

Moderate

Steps

6

Time Required

                          20 minutes

Sections

2

  • Camera Lens and Cover
  • 4 steps
  • Capture Button
  • 2 steps

Flags

0

  • BackiON SnapCam 1046 Lite

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera Lens and Cover
  • Remove any external skins placed on the device. To do so, simply lift up and peel to remove.

Remove any external skins placed on the device. To do so, simply lift up and peel to remove.

1024

Step 2

  • Firmly pull on the back clip in order to remove.

Firmly pull on the back clip in order to remove.

Step 3

  • Use a Phillips head screwdriver to remove the four 4mm PH00 screws located on the sides of the device. All screws are located under each of the grey covers for the microSD card and the microUSB insert.

Use a Phillips head screwdriver to remove the four 4mm PH00 screws located on the sides of the device. All screws are located under each of the grey covers for the microSD card and the microUSB insert.

Step 4

  • Grab a metal or plastic opening tool and insert it into the middle slot on the bottom of the camera and lightly pry open.
  • Locate the camera lens in the bottom left-hand corner of the picture which can be replaced by replacing the entire cover. The back of the cover is also shown. The camera is now located in the top right-hand corner of the picture.

Grab a metal or plastic opening tool and insert it into the middle slot on the bottom of the camera and lightly pry open.

Locate the camera lens in the bottom left-hand corner of the picture which can be replaced by replacing the entire cover. The back of the cover is also shown. The camera is now located in the top right-hand corner of the picture.

Step 5

              Capture Button
  • Remove the motherboard by pulling it from the edges as circled.

Remove the motherboard by pulling it from the edges as circled.

Step 6

  • Replace capture button with advanced soldering and circuitry (circled in red).

Replace capture button with advanced soldering and circuitry (circled in red).

Once the capture button has been replaced, reassemble the iON SnapCam Lite by following these steps in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Ahmad Syamil Ali

Member since: 11/20/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       IUPUI, Team S22-G4, Bayer Fall 2017                        

                                                  Member of IUPUI, Team S22-G4, Bayer Fall 2017 



                    IUPUI-BAYER-F17S22G4                     


                                            5 Members                     


                                            4 Guides authored