Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Battery
  • 4 steps
  • Motherboard
  • 2 steps

Flags

0

  • BackiON SnapCam 1045

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Detach the magnetic clip from the bottom of the camera.
  • The magnetic clip gets in the way of disassembly because it constantly spins and therefore a distraction so it is imperative to detach.

Detach the magnetic clip from the bottom of the camera.

The magnetic clip gets in the way of disassembly because it constantly spins and therefore a distraction so it is imperative to detach.

1024

Step 2

  • Use a spudger to gently detach the memory card and USB slot cover.

Use a spudger to gently detach the memory card and USB slot cover.

Step 3

  • Use a Phillips #000 Screwdriver to loosen the 0.008 mm screw located between the USB and memory card slots.
  • This screw is really tiny and can easily fall off and get lost! Make use of a magnetic mat to hold it in place or better still put the magnetic clip to use for keeping the screw safe.

Use a Phillips #000 Screwdriver to loosen the 0.008 mm screw located between the USB and memory card slots.

This screw is really tiny and can easily fall off and get lost! Make use of a magnetic mat to hold it in place or better still put the magnetic clip to use for keeping the screw safe.

Step 4

  • Once again use the spudger to gently open the encasement.
  • The case is a little fragile and forceful entry could lead to damage of the plastic case. Thread carefully.
  • The Battery can be safely detached and replaced.

Once again use the spudger to gently open the encasement.

The case is a little fragile and forceful entry could lead to damage of the plastic case. Thread carefully.

The Battery can be safely detached and replaced.

Step 5

              Motherboard
  • To get to the motherboard, safely lift the battery to expose an Aluminium plate that shields and holds the motherboard in place.
  • The plates are held down by four Phillips 0.008 mm screws on all four corners. Use a Phillips head #000 to safely loosen the screws.

To get to the motherboard, safely lift the battery to expose an Aluminium plate that shields and holds the motherboard in place.

The plates are held down by four Phillips 0.008 mm screws on all four corners. Use a Phillips head #000 to safely loosen the screws.

Step 6

  • To replace the motherboard gently insert a plastic opening tool into one end and lift up.
  • Be careful to avoid inserting material that is rough and too sturdy as it can damage components on the motherboard.

To replace the motherboard gently insert a plastic opening tool into one end and lift up.

Be careful to avoid inserting material that is rough and too sturdy as it can damage components on the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Jessica Matias

Member since: 12/09/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S3-G3, Wilson Fall 2017                        

                                                  Member of IUPUI, Team S3-G3, Wilson Fall 2017 



                    IUPUI-WILSON-F17S3G3                     


                                            3 Members                     


                                            3 Guides authored