Inter Tel Ip 8660 Handset Microphone And Receiver Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          5 minutes            

Sections

2

• Handset Back Cover
• 3 steps
• Handset Microphone and Receiver.
• 3 steps

Flags

1

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

• BackInter-tel IP 8660

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Handset Back Cover               

• Disconnect the phone cord from the handset jack.

Disconnect the phone cord from the handset jack.

1024

Step 2

• Unscrew the two black screws (8 mm long) located in the middle of the handset using #1 Phillips head.

Unscrew the two black screws (8 mm long) located in the middle of the handset using #1 Phillips head.

Step 3

• Pry the back cover off the headset using a spudger. It is best to pry at the top of the handset.

Pry the back cover off the headset using a spudger. It is best to pry at the top of the handset.

Step 4

              Handset Microphone and Receiver.               

• While holding the handset front cover, grasp and twist the handset microphone and jack until they come free from the cover.

While holding the handset front cover, grasp and twist the handset microphone and jack until they come free from the cover.

Step 5

• Unscrew the 2 screws (8 mm long) that hold the receiver in place using a #1 Phillips screwdriver.
• Note: The screws come with washers.

Unscrew the 2 screws (8 mm long) that hold the receiver in place using a #1 Phillips screwdriver.

Note: The screws come with washers.

Step 6

• Pull the red and green wires that connect the receiver to the microphone out from under the metal piece and black padding.
• Note: To insert the wires back underneath the black padding, pull the black padding back with your finger and use plastic opening tool to wedge the wires underneath the black padding.

Pull the red and green wires that connect the receiver to the microphone out from under the metal piece and black padding.

Note: To insert the wires back underneath the black padding, pull the black padding back with your finger and use plastic opening tool to wedge the wires underneath the black padding.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Juan David GutierrezFranco                     

Member since: 01/20/2012

67 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       Cal Poly, Team 11-24, Maness Winter 2012                        

                                                  Member of Cal Poly, Team 11-24, Maness Winter 2012 



                    CPSU-MANESS-W12S11G24                     


                                            4 Members                     


                                            14 Guides authored