Difficulty

Moderate

Steps

11

Time Required

                          40 minutes

Sections

1

  • Petsafe Dog Panel
  • 11 steps

Flags

0

  • BackPet Supply

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Petsafe Dog Panel
  • Make sure you have all the tools necessary.

Make sure you have all the tools necessary.

1024

Step 2

  • Receive your PetSafe dog door in the mail.

Receive your PetSafe dog door in the mail.

Step 3

  • Measure the height of the sliding glass door frame.

Measure the height of the sliding glass door frame.

Step 4

  • Remove your lock latch from the sliding door frame.
  • Lock latches may vary

Remove your lock latch from the sliding door frame.

Lock latches may vary

Step 5

  • Slide the top of your dog panel into the top track of the sliding glass door.
  • Place the bottom portion of the dog panel into the bottom track of the sliding glass door.

Slide the top of your dog panel into the top track of the sliding glass door.

Place the bottom portion of the dog panel into the bottom track of the sliding glass door.

Step 6

  • Measure 12” from the top, down the side of your sliding glass door frame and mark it.
  • Mark 1” above the pet flap onto the edge of your sliding glass door.

Measure 12” from the top, down the side of your sliding glass door frame and mark it.

Mark 1” above the pet flap onto the edge of your sliding glass door.

Step 7

  • With a 9/64ths drill bit, drill clearance holes into the marks made on the sliding glass door frame
  • DO NOT GO THROUGH THE DOG PANEL

With a 9/64ths drill bit, drill clearance holes into the marks made on the sliding glass door frame

DO NOT GO THROUGH THE DOG PANEL

Step 8

  • Fasten the panel to the interior side of the sliding glass frame with the provided ⅝” screws.
  • MAKE SURE YOU ARE DRILLING OUTSIDE OF THE RIBBED LINE ON THE DOG PANEL.
  • DO NOT OVERTIGHTEN.

Fasten the panel to the interior side of the sliding glass frame with the provided ⅝” screws.

MAKE SURE YOU ARE DRILLING OUTSIDE OF THE RIBBED LINE ON THE DOG PANEL.

DO NOT OVERTIGHTEN.

Step 9

  • Tighten the screws with a screwdriver.

Tighten the screws with a screwdriver.

Step 10

  • Repeat steps 8 and 9 to secure the dog panel into place. Follow these steps when drilling into the clearance hole marked at the top of the frame.

Repeat steps 8 and 9 to secure the dog panel into place. Follow these steps when drilling into the clearance hole marked at the top of the frame.

Step 11

  • Slide your sliding door flush against the dog door.

Slide your sliding door flush against the dog door.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Joshua Novello

Member since: 10/26/2018

196 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       UC Davis, Team S1-G1, Bender Fall 2018                        

                                                  Member of UC Davis, Team S1-G1, Bender Fall 2018 



                    UCD-BENDER-F18S1G1                     


                                            3 Members                     


                                            1 Guide authored