Difficulty
Very easy
Steps
3
Time Required
5 seconds - 10 minutes
Sections
1
- Installation/Removal of the WIC/HWIC card
- 3 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackCisco router 1900 series
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Featured Document
Step 1
Turn the equipment off
- In order to install or remove a card the equipment should be turned off.
In order to install or remove a card the equipment should be turned off.
1024
Step 2
Remove the port covers on the EHWIC
- Loosen the cards’ screws.
- Do not remove them completely. Once they are loose the spring will push the screw outwards.
- To remove, pull on the card.
- It is recommended that you clean the card of dust.
Loosen the cards’ screws.
Do not remove them completely. Once they are loose the spring will push the screw outwards.
To remove, pull on the card.
It is recommended that you clean the card of dust.
Step 3
Insert the card
- Insert the card or install the protective router cover to avoid dust accumulation.
Insert the card or install the protective router cover to avoid dust accumulation.
To re-assemble your device, follow these instructions in reverse.
Cancel: I did not complete this guide.
One other person completed this guide.
WhoDat? is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
WhoDat?
Attached Documents
- Cisco-1900-Series-Integrated-S.pdf
- PDF - 301.42 kb
- View
Cisco-1900-Series-Integrated-S.pdf
PDF - 301.42 kb
Author
with 1 other contributor
Eneider Colina
Member since: 09/20/2013
2,332 Reputation
9 Guides authored
Badges:
20
+17 more badges
Team
Comunidad para traductores de español
Member of Comunidad para traductores de español
Community
18 Members
23 Guides authored
