Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

2

  • Battery
  • 4 steps
  • Front Case Cover
  • 4 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackInsignia Sport NS-4V17

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.

Remove the 3mm Phillips #00 screw on the back of the Insignia NS-4v17.

1024

Step 2

  • Detach the back cover by carefully pulling up and out on the back plastic casing.
  • Do not pull apart the red wire connecting the battery to the device.

Detach the back cover by carefully pulling up and out on the back plastic casing.

Do not pull apart the red wire connecting the battery to the device.

Step 3

  • Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.
  • Be careful to not tear the wires while opening the case.

Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.

Be careful to not tear the wires while opening the case.

Step 4

  • Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.
  • Do not disconnect wires from plastic connector.

Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.

Do not disconnect wires from plastic connector.

Step 5

              Front Case Cover
  • Remove the four corner plastic covers on the back of the device using the plastic opening tool.

Remove the four corner plastic covers on the back of the device using the plastic opening tool.

Step 6

  • Using a Philips #00 screwdriver remove all four 4.5mm corner screws located underneath the corner pads.

Using a Philips #00 screwdriver remove all four 4.5mm corner screws located underneath the corner pads.

Step 7

  • Carefully wedge the plastic opening tool into either long side of the device.
  • Slowly move the plastic opening tool along the side of the device, separating the front and back case covers.
  • Repeat these steps on the other side of the device.

Carefully wedge the plastic opening tool into either long side of the device.

Slowly move the plastic opening tool along the side of the device, separating the front and back case covers.

Repeat these steps on the other side of the device.

Step 8

  • Once the front cover is loose, use your fingers to remove the front case cover for a new installation.

Once the front cover is loose, use your fingers to remove the front case cover for a new installation.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Wesley Ballar

Member since: 04/18/2013

88 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 12-36, Amido Spring 2013                        

                                                  Member of Cal Poly, Team 12-36, Amido Spring 2013 



                    CPSU-AMIDO-S13S12G36                     


                                            4 Members                     


                                            5 Guides authored