Difficulty
Moderate
Steps
2
Time Required
10 minutes
Sections
1
- Stick Vacuum Power Button
- 2 steps
Flags
0
BackInsignia NS-VCS14SL7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Stick Vacuum Power Button
- Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle.
- Pull up on the back cover of the vacuum handle and remove it.
Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle.
Pull up on the back cover of the vacuum handle and remove it.
1024
Step 2
- Remove the two 10mm Phillips #2 screws on the back of the green printed circuit board.
- If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.
Remove the two 10mm Phillips #2 screws on the back of the green printed circuit board.
If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Thibaut Pillot
Member since: 02/15/2018
434 Reputation
5 Guides authored
Badges:
3
Team
USF Tampa, Team S16-G3, Boczar Spring 2018
Member of USF Tampa, Team S16-G3, Boczar Spring 2018
USFT-BOCZAR-S18S16G3
4 Members
12 Guides authored
